Overview
The G2 Axle and Gear GM 14B 10.5-inch Minor R&P Install Kit, part number 25-2023B, is a minor ring and pinion installation kit titled for the GM 14B axle in the 10.5-inch size. Its UPC is 631410126716.
R&P stands for ring and pinion. The kit’s listed parts are itemized below.
Before setting up the gears
A minor ring and pinion kit is built for a gear change where the carrier bearings are reused, so the condition of those bearings decides whether the job is complete. Look for pitting, rust, rough rotation and heat discoloration before reassembly. If the bearings or races show wear, a master kit or new bearings are the safer choice. The gears should also be set up on a clean bench with the housing free of old gasket material.
Setting pinion depth, preload and backlash takes patience. Shims move the pinion in and out and set how the ring gear sits, and each change needs a new check. Marking compound on the teeth shows contact pattern, which is how most installers confirm the shim choice. Reusing old crush sleeves or seals invites leaks and preload problems, so fresh parts suit a clean rebuild.
- Inspect carrier bearings before reusing them
- Replace the pinion seal whenever the pinion is pulled
- Use a new crush sleeve, not a reused one
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2023B |
| UPC | 631410126716 |
| Kit type | Minor |
| Axle | GM 14B, 10.5-inch |
Vehicle fitment
It is for the GM 14B axle in the 10.5-inch size.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth and bearing preload on a 14B axle should be set by a qualified gear technician, not by trial and error.
What’s included
- Pinion nut
- Pinion seal
- Crush sleeve
- Pinion shims
- Carrier shims
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer







