Overview
The G2 Axle and Gear 97-2032-008 is a chromoly driver-side front inner axle shaft for the Dana 30 in the 1982–1986 Jeep CJ5, CJ7 and Scrambler. It has 30 splines and accepts a 5-760X U-joint.
The 97-2032-008 is machined to accept full circle clips. This shaft is forged from high-grade alloy steel and heat treated for extended service life.
The 97-2032-008 is a driver-side chromoly inner shaft with 30 splines for the standard Dana 30 in 1982–1986 CJ models. It is machined for full circle clips and accepts a 5-760X U-joint. G2 Axle and Gear says its shafts are heat treated to exceed OEM specifications for extended service life.
Key features
- Chromoly inner axle shaft for the Dana 30
- 30 splines
- Accepts a 5-760X U-joint
- Machined for full circle clips
- Driver-side inner shaft
- Front axle
Older CJ axle wear
Axles on 1982 and later CJs have usually seen decades of trail use, so the inner shafts often show age as well as load. Corrosion at the splines and a dry clip groove are common, and both can make a shaft harder to remove. Cleaning the spline end and the clip groove before installation makes the new part easier to seat and easier to service later.
Because the inner shaft works against the side gear, a worn gear can damage a new shaft in a short time. Check for rounding on the gear teeth, and inspect the seal at the differential for leaks that could contaminate the shaft. If the outer shaft and U-joint are worn, replacing them at the same time keeps the driveline balanced.
- Clean corrosion from the spline end
- Check the clip groove before installing
- Inspect the differential seal for leaks
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2032-008 |
| UPC | 631410097108 |
| Product type | Replacement axle shaft |
| Axle type | Dana 30 Standard |
| Axle location | Front |
| Shaft position | Driver Side Inner |
| Spline count | 30 |
| Material | Chromoly |
| U-joint | 5-760X |
| Axle end | Machined for full circle clips |
| Stated application | 82-86 Jeep CJ |
Vehicle fitment
Coverage is the 1982–1983 Jeep CJ5, the 1982–1986 Jeep CJ7 and the 1982–1985 Jeep Scrambler.
The list starts at 1982, so earlier CJs are not covered, and the CJ5 ends at 1983. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Check the U-joint is the 5-760X type before fitting the 97-2032-008.
- The 30-spline shaft has to match your Dana 30 gears.
What’s included
One driver-side inner axle shaft (97-2032-008).
Not included: the outer shaft, U-joint and clips for the 97-2032-008.





