Overview
The G2 Axle and Gear Ford 9 inch internal kit, part number 20-2011, is a replacement gear set for a Ford 9 inch rear axle with 31 splines. It uses a two spider gear design and is built for open differentials.
The kit is meant to replace worn or damaged internal gears, so it suits a rebuild that keeps the existing carrier.
Key features
- Two spider gear design
- 31 spline axle
- Built for open differentials
- Includes side gears, spider gears, thrust washers and cross shaft
Rebuild planning tips
A rear axle gear set is one part of a larger rebuild, and the way the carrier is assembled matters as much as the gears themselves. Gear contact pattern, backlash and pinion preload all have to be set with the carrier in the axle housing, which is why most owners hand this work to a shop with the right setup tools. A careful check at each step prevents the noise and early wear that come from a rushed assembly.
Two-spider designs are common in open differentials, and the spider gears and thrust washers wear together. If one part is worn, replacing only the gears can leave the others mismatched. Inspect the cross shaft and side gear bores for scoring, and replace the parts that show damage so the new set runs smoothly.
- Check gear contact pattern before closing the carrier
- Inspect cross shaft and bores for scoring
- Use fresh gear oil after the break-in run
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 20-2011 |
| Component | Internal gear kit |
| Design | Two spider gear |
| Axle type | Ford 9 Inches |
| Axle location | Rear |
| Axle spline | 31 splines |
| Case type | Open |
Vehicle fitment
The kit fits the Ford 9 Inches rear axle type. Confirm the axle in your vehicle before ordering, since no model year range is tied to the kit.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Assembly should go to a shop that checks gear contact and carrier preload. The new gears need a break-in run before the vehicle sees heavy use.
What’s included
Included: side gears, spider gears, thrust washers and a cross shaft. No retaining pin is named for this kit.





