Overview
The Dana Spicer 708204 is a Trac-Lok limited slip differential gear set for Dana 44 axles. The internal kit replaces the internal components of a standard open differential. It is a direct fit for a 30-spline axle with gears of 3.73 and lower.
The internal kit is forged for strength and durability. The cross shaft has a phosphate coating, and the parts are heat treated under statistical control. The kit eliminates the clunking that worn spider gears cause and tightens up loose differentials.
It does not fit JK differentials.
Key features
- Forged internal kit for greater strength and durability
- Phosphate coated cross shaft
- Statistically controlled heat treating
- Eliminates clunking caused by worn spider gears
- Trac-Lok limited slip differential internals
Choosing and setting up gears
A limited slip differential sends torque to both wheels when one loses grip, which helps a Dana 44 keep moving on loose dirt, rocks and mud. An open differential can spin one wheel while the other stands still, so the upgrade matters most for trail and off-road use. Gear ratio matters too. Internal gears should match the ring and pinion already in the axle, so check the existing ratio before buying internals.
Setup and break-in deserve as much attention as the parts. Pinion preload, ring and pinion backlash and carrier bearing preload all affect how the gears wear and how quiet they run. A shop with the right tools usually handles this best. After the first drives, inspect for leaks, listen for unusual noise and check the fluid, using a lubricant made for limited slip units.
- Measure the existing gear ratio before ordering
- Confirm the axle spline count matches the kit
- Ask the shop to verify preload and backlash
- Use the friction additive the fluid calls for
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 708204 |
| Case type | Limited slip (Trac-Lok) |
| Axle type | Dana 44 |
| Axle spline | 30 splines, 1.31-inch spline diameter |
| Internal gear ratio | 3.73 and down |
| Cross shaft | Phosphate coated |
| Not for | JK differentials |
| Fitment | Direct fit |
Vehicle fitment
It fits 1990–2001 Jeep Cherokee (XJ), 1990–1992 Comanche, 1999–2001 and 1993–1998 Grand Cherokee (WJ and ZJ), 1990 Wagoneer (SJ), 1990–1995 Wrangler (YJ), 1997–2006 Wrangler (TJ) and 2004–2006 Wrangler (LJ) models.
JK models are not covered. Confirm front or rear axle position and your vehicle’s year, model and trim before ordering.
Installation notes
Gear sets and limited slip internals on a Dana 44 call for professional setup and break-in. The kit covers internal gears of 3.73 and lower, so higher ratios are not covered.
What’s included
The Trac-Lok limited slip internal gear set.







