Overview
The G2 Axle and Gear GM 7.5 inch internal kit is a set of replacement internal gears for a GM 10 bolt 7.5 inch rear axle with an open differential case. It is meant to replace worn or damaged gears without replacing the complete differential carrier.
The kit is listed with a 28 spline axle. No vehicle year, make or model is named, so confirm the axle type before ordering.
Key features
- Replacement internal gears for open differential cases
- Side gears, spider gears, thrust washers, cross shaft and retaining pin
- 28 spline axle
- Rear axle location
Gear set setup and break-in
Replacement internal gears change how the carrier carries load, so the work goes beyond swapping parts. Gear mesh, contact pattern and bearing preload all have to be set before the carrier goes back in. Shops usually check the contact pattern with marking compound and adjust shims until both drive and coast sides look right.
Inspect the case and bearings before installing new gears. Cracks, galling or heavy wear in the case mean the carrier should be repaired rather than fitted with new gears alone. Once the gears are in, expect a break-in period with gentle loading to let the contact surfaces settle.
- Look for debris in the case before reassembly
- Check bearing play and replace worn bearings
- Use the correct gear oil for the carrier
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| UPC | 631410093261 |
| Component | Internal gear kit |
| Case type | Open |
| Axle type | GM 10 Bolt 7.5 Inches |
| Axle location | Rear |
| Axle spline | 28 splines |
Vehicle fitment
It is made for GM 10 bolt 7.5 inch rear axles. Check your axle type and spline count before ordering.
It is made for open differential cases, not limited slip carriers. Check your carrier’s case type before ordering.
Installation notes
Gear sets of this type call for professional setup, since mesh and bearing preload must be dialed in before the carrier goes back together. Expect a break-in period for the new gears afterward.
What’s included
Included: side gears, spider gears, thrust washers, cross shaft and retaining pin. Not included: a complete differential carrier is not part of this kit.




