Overview
The G2 Axle and Gear 95-2013-020 is a rear driver-side replacement axle shaft for the Ford 8.8 inch axle in the 1995–2002 Ford Explorer. It is forged from 1541H steel and has 31 splines and a 5 on 4.5 bolt pattern.
This shaft is forged from 1541H steel, and the heat treatment affects how the splines and flange hold up under load. It is designed for high-torque use. Its 31-spline count must match the side gears in the 8.8 inch axle, and its 5 on 4.5 bolt pattern has to match the wheels.
The 95-2013-020 is described by G2 Axle and Gear as a forged 1541H steel shaft, a spec that tells you the alloy rather than leaving it at high grade alloy steel. Its 5 on 4.5 bolt pattern and 31 splines are listed in the specification table. G2 also says its shafts are heat treated to exceed OEM specifications and engineered for the added load of high-torque use, which suits a trail Explorer.
Key features
- Forged 1541H steel
- 31 splines
- 5 on 4.5 bolt pattern
- Left-hand (LH) driver-side shaft
- Fits the Ford 8.8 inch rear axle
- Heat treated beyond OEM specs
Fitment and axle matching
The 1541H steel used in this shaft is a forged alloy, and the heat treatment affects how the splines and flange hold up under load. Keep the shaft matched to the axle’s side gears and bolt pattern, and check both before the old part comes out.
The 8.8 inch axle in Explorers has a 31-spline count on the side gears, so a shaft with a different count will not work. Measure the splines on the old shaft if one is still installed, and compare the 5 on 4.5 bolt pattern with the hub.
Drivers who run the Explorer on trails should check the seal, bearing and flange every time a wheel comes off. Look for grease on the brake parts, rough bearing feel and cracked flanges. Replace any part that shows wear before it fails on the trail.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2013-020 |
| UPC | 631410106329 |
| Product type | Replacement axle shaft |
| Axle type | Ford 8.8 inch |
| Axle location | Rear |
| Shaft position | Driver Side |
| Spline count | 31 |
| Material | Forged 1541H steel |
| Bolt pattern | 5 on 4.5 |
| Stated application | 95-Up Explorer |
Vehicle fitment
It fits the 1995–2002 Ford Explorer on the Ford 8.8 inch rear axle.
Fitment here follows G2’s title and short description rather than a full model list. Later Explorers are a redesigned vehicle and should not be assumed to fit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- The shaft has a 5 on 4.5 bolt pattern, so check it against your wheels before installing.
- The 31-spline count has to match the differential side gears in the Explorer’s 8.8 inch axle.
What’s included
One left-hand rear axle shaft (95-2013-020).
Not included: Wheel studs.








