Overview
The G2 Axle and Gear 1350 Series pinion yoke, part number 90-2013-35U, is a U-bolt style yoke built for a Ford 8.8 Inch rear axle. Its 1350 Series U-joint and rear location are the two points to match before fitting.
U-bolt mounting is the design here, and the yoke is a universal fit part. That category names no vehicle, so the Ford 8.8 Inch axle type drives compatibility.
Key features
- U-bolt style yoke for a 1350 Series U-joint
- Rear axle location
- Designed for the Ford 8.8 Inch axle type
- Part of G2’s range of pinion flanges and yokes for several applications
Before removing the old yoke
Before the old yoke comes off, mark the driveshaft and pinion positions so the driveline can go back in the same orientation. A worn yoke can hide a flange that has been pulled out of square, so check the pinion splines and the yoke ears for wear. Clean the pinion shaft before fitting the new part, because rust or debris under the yoke can cause it to seat unevenly.
U-bolt yokes depend on clamp fit more than strap designs, so the clamps and saddle surfaces should be inspected for flattening or cracks. A pinion yoke replacement often pairs with a new pinion seal and sometimes a pinion bearing. Once the yoke is on, recheck the U-joint angles and driveline balance after the first drive.
- Mark driveshaft and pinion orientation
- Inspect clamp saddles for flattening
- Replace the pinion nut after removal
- Recheck driveline angles after the first drive
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 90-2013-35U |
| UPC | 631410122916 |
| Yoke style | U-bolt style |
| U-joint series | 1350 Series |
| Axle location | Rear |
| Axle type | Ford 8.8 Inches |
| Listed fitment category | Universal Fit |
Vehicle fitment
No vehicle is named for this yoke. The compatibility details are the Ford 8.8 Inch axle type, the rear location and the 1350 Series joint.
Front axles and other joint series are outside these details. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
U-bolt clamps have to suit the pinion flange and the axle, so check the clamp hardware before removal. Pinion nut torque and bearing preload are set at reassembly, which calls for a qualified driveline technician.
What’s included
The package is the yoke. Plan for U-bolts, a pinion nut and a seal if your installation needs them.









