Overview
G2 Axle and Gear’s 90-2021-35U is a U-bolt style pinion yoke for GM 10 Bolt 8.5 Inch axles with a 1350 Series U-joint.
It is a universal fit part, so compatibility comes down to the GM 10 Bolt 8.5 Inch axle type, the 1350 Series joint and the axle location.
Key features
- U-bolt style mounting on a 1350 Series U-joint
- Fits front and rear axle locations.
- GM 10 Bolt axle type, 8.5 Inches
- Part of G2’s yokes built for multiple applications
Matching the axle location
Front and rear pinion yokes are often sourced by axle type rather than by vehicle, and GM 10 Bolt axles appear in a range of applications. Measure the existing yoke bore, the spline count and the U-joint cup size before ordering, since those dimensions decide whether the new yoke will seat. A U-bolt design also relies on clamp saddles that match the pinion flange.
When a front or rear yoke is swapped in the same job, check that the new pinion has a matching spline count and that the axle seal is in good condition. Worn yokes often leave a slight wobble at the flange, which shortens U-joint life. After installation, a driveline check for angle and runout is a sensible step.
- Measure the pinion spline count
- Compare U-joint cup size before ordering
- Inspect the axle pinion seal during the swap
- Confirm clamp saddles fit the flange
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 90-2021-35U |
| UPC | 631410122985 |
| Yoke style | U-bolt style |
| U-joint series | 1350 Series |
| Axle location | Rear and front |
| Axle type | GM 10 Bolt 8.5 Inches |
| Listed fitment category | Universal Fit |
Vehicle fitment
No vehicle is named for this yoke. The match points are the GM 10 Bolt 8.5 Inches axle type, the 1350 Series joint and the front or rear location.
Other axle designs and other U-joint series are outside these details. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the mounting is U-bolt style, the clamps must suit the pinion flange and the axle location. A qualified driveline shop should set the pinion preload and confirm the driveshaft angles after the swap.
What’s included
Check the package contents against your installation before starting, including the clamp hardware, pinion nut and seal.









