Overview
The G2 Axle and Gear 92-2052-7 is a heavy duty double cardan CV style rear drive shaft for the Jeep Wrangler JK. G2 Axle and Gear offers it as a replacement shaft for JK models with an automatic transmission, and recommends it for stock to 6 inch lift setups.
The shaft is built from heavy duty D.O.M. tubing and uses solid body U-joints in a 1350 size. Each unit is dynamically balanced to help eliminate vibration. Tire clearance is up to 37 inches.
Key features
- Heavy duty D.O.M. tubing for strength
- Solid body U-joints for durability
- Double cardan CV style joints
- Dynamically balanced, which G2 says eliminates vibration
- Recommended for stock to 6 inch lift
- Tire clearance noted up to 37 inches
- Rear position for JK models
Planning a lift and tire setup
Lift height changes driveline angles, and larger tires add load and rotational weight to the drivetrain. Both can shift how the rear shaft works, so the lift and tire size should be settled before the shaft is measured and fitted. Replacing a shaft during a lift is common because the old one was set for stock geometry.
Related parts are often replaced at the same time. Lift springs, extended brake lines and a new pinion flange bolt set can all change the driveline, so review them together. Keep a record of the shaft length you installed in case future lifts require a different length.
- Measure driveline angles after the lift is complete
- Check transfer case output and rear pinion alignment
- Inspect the rear U-joints when changing tire size
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 92-2052-7 |
| UPC | 92205270005 |
| Position | Rear |
| Drive shaft type | Double cardan CV |
| U-joint size | 1350 |
| Tubing | Heavy duty D.O.M. |
| Balance | Dynamically balanced |
| Lift height maximum | 6 inches |
| Maximum tire size | 37 inches |
| Transmission | Automatic |
| Body | 2-door models |
Vehicle fitment
It fits the Jeep Wrangler JK from 2007 to 2018, in 2-door models with an automatic transmission.
The rear extended-length CV shaft is Universal Fit and needs no slip yoke eliminator. Check shaft length and transmission type against your vehicle before choosing this part.
It is not made for the Wrangler YJ, TJ or LJ, the JL generation, the Gladiator, or the Cherokee and Grand Cherokee. Check your year, model and trim against the fit before buying.
Installation notes
Lift height changes driveline angles, so measure the angles after fitting the shaft to a lifted Wrangler. The fitment chart flags which lengths need a slip yoke eliminator, so confirm that before installation.
What’s included
The shaft itself is the only item included. Verify it against your installation plan before starting.

















