Overview
The G2 Axle and Gear Double Cardan CV Style Rear Drive Shaft, part number 92-2052-4, is a heavy duty replacement rear driveshaft for four-door Jeep Wrangler JK models with an automatic transmission. G2 Axle and Gear offers it as a rear replacement for the JK models with a stock to 6 inch lift.
The shaft is built from heavy duty D.O.M. tubing, uses solid body U-joints for durability, and is dynamically balanced to reduce vibration. The rating covers stock height up to a 6 inch lift and tires up to 37 inches.
Key features
- Heavy duty D.O.M. tubing for strength
- Solid body U-joints for durability
- Dynamically balanced to eliminate vibration
- Double Cardan CV style driveshaft type
- Rated for stock to 6 inch lift
- Rated for tires up to 37 inches
Driveline wear and inspection
A driveshaft carries engine torque from the transmission and transfer case to the rear axle, and its joints must allow the driveline to flex through changing angles. Double cardan CV joints are used where angles change, which is common on a lifted Wrangler. Worn joints usually show up as a clunk when shifting between drive and reverse, vibration that rises with road speed, or grease leaking from the cap seals.
Because this shaft bolts to the rear axle pinion, check the pinion yoke and flange bolts at the same time. Loose hardware produces vibration that is easy to mistake for a bad shaft. After rock crawling or striking an obstacle, inspect the tube for dents, since even a small dent can upset balance.
- Check each joint for play by hand with the vehicle safely supported
- Re-check yoke and flange bolts after the first few trail runs
- Note any vibration that changes with speed or throttle
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 92-2052-4 |
| UPC | 92205240008 |
| Position | Rear |
| Driveshaft type | Double Cardan CV |
| U-joint | 1350 |
| Tubing | Heavy duty D.O.M. |
| Maximum lift height | 6 inches |
| Tire size | Up to 37 inches |
| Body style | 4-door |
| Transmission | Automatic |
Vehicle fitment
This rear shaft fits four-door Jeep Wrangler JK models (2007-2018) with an automatic transmission.
Two-door JK models use a separate rear shaft in this line, part 92-2052-7. Other Wrangler generations, such as the TJ and JL, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The fitment table marks this rear shaft as not requiring a slip yoke eliminator. After any lift, check driveline angles and vibration, since the rating covers up to a 6 inch lift.
What’s included
One rear Double Cardan CV drive shaft assembly. Compare the delivered parts with your installation plan before starting.
















