Overview
The G2 97-2045-002 is a chromoly inner axle shaft for the passenger side of a Dana 44 front axle. It has 30 splines, an overall length of 31.88 inches and accepts a 5-760X U-joint.
G2 Axle and Gear says its high strength axle shafts are engineered to withstand the added load of high torque applications and to remedy common faults found in factory shafts. The shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications.
The shafts are designed to handle added load in high torque applications. Big spline options, rolled splines and better materials let owners run larger tires with less risk of failure, and the shafts are built for an extended service life.
This is a passenger side inner shaft for Dana 44 front axles. Confirm fit for your vehicle’s year, model and trim before buying.
Key features
- Chromoly inner shaft for the passenger side
- 30 spline shaft end
- Accepts a 5-760X U-joint
- Machined to accept full circle clips
- Forged alloy steel, heat treated
Checking the axle before install
An inner axle shaft carries drive torque from the differential to the hub, and it works under changing angles as the suspension moves. Because the shaft is a wear item, it helps to know what a failing one looks like. Worn splines, a cracked shaft end or a bent shaft are all reasons to replace the part before it fails under load.
Before buying, measure the old shaft and compare the spline count, overall length and U-joint size. Check the axle seals and bearings while the axle is open, since a leaking seal can contaminate a new shaft. Retainer style also matters, so confirm the clip type the axle uses.
- Count the splines on the old shaft
- Measure overall length end to end
- Inspect the axle seal for leaks
- Replace the U-joint with the shaft if it is worn
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2045-002 |
| UPC | 631410097375 |
| Axle location | Front |
| Axle type | Dana 44 |
| Position | Passenger side inner |
| Spline | 30 |
| Overall length | 31.88 inches |
| U-joint | 5-760X |
| Retainer | Machined for full circle clips |
| Material | Chromoly |
Vehicle fitment
Match the Dana 44 front axle and the passenger side, then confirm fit by year, model and trim before buying.
Measure your axle and compare it with the spline count and overall length before ordering.
Installation notes
The shaft is for the passenger side only, so match the side before fitting. Because it is machined for full circle clips and a 5-760X U-joint, check that both are compatible with the axle before installation.
What’s included
The item is a single passenger side inner axle shaft. Hardware and the U-joint are not part of this item.








