Overview
The G2 Dana 44 Internal Kit, part 20-2033, is a set of replacement internal gears for an open Dana 44 differential, with 30 splines. It covers the gear set without the rest of the carrier.
The kit lets you replace damaged or worn gears without replacing the whole differential carrier. It is offered for front and rear Dana 44 and Dana 44 JK axles.
Key features
- Replacement side gears and spider gears
- Thrust washers included
- Cross shaft and retaining pin included
- 30 spline
- For open differentials
Gear wear and setup
Differential gears wear from heat, shock loads and poor lubrication, and the first sign is often a whine that changes with speed or load. Gear contact that is off-center can cause chipping at the tooth edges. When the internals are replaced, a fresh set of thrust washers helps keep the side gears from wearing into the carrier case.
Setting the backlash and contact pattern is the most important part of the work. Use a dial indicator and mark the gear teeth with a contact compound before the cover goes on. Fresh gear oil and a clean carrier interior help the new parts break in evenly during the first few drives.
- Check backlash at several points around the ring gear
- Look for chipping or uneven wear on the tooth faces
- Replace thrust washers when the internals are changed
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 20-2033 |
| UPC | 631410093353 |
| Axle location | Front or rear |
| Axle types | Dana 44, Dana 44 JK |
| Differential type | Open |
| Spline | 30 |
Vehicle fitment
Universal fit is listed, but no vehicle is named. The kit is for 30 spline open Dana 44 differentials, so confirm the axle and spline count before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear work needs a proper setup: backlash and gear contact should be checked when the internals are installed in the carrier.
What’s included
Side gears, spider gears, thrust washers, a cross shaft and a retaining pin.









