Overview
The Dana Spicer 2009155 is a differential carrier gear kit for a Dana Super 44 rear axle with a 30 spline open differential. It contains the spider gears and side gears that sit inside the differential case, so it is the set installed when the carrier is rebuilt. It fits the 2007-2013 Jeep Wrangler (JK).
The gears are forged for greater strength and durability than standard gears. The kit includes the differential and side gears, the thrust washers, the cross shaft and the hardware for assembly. It is a genuine Dana Spicer inner gear kit engineered to Dana standards, so it can replace the original gears when a rebuild calls for new internals.
Key features
- Genuine Dana Spicer inner gear kit for an open differential
- Built for a 30 spline open differential in the Dana Super 44
- Forged gears for greater strength and increased durability
- Includes differential and side gears, thrust washers and cross shaft
- Hardware included for assembly
Rebuilding the carrier
A carrier rebuild is usually triggered by noise, heat or metal in the gear oil. Inside the case, the spider gears carry load between the side gears, so wear there can show up as clunking on turns or uneven power at the wheels.
When the case is open, inspect the ring and pinion, the carrier bearings and the case halves. Pitting, chipped teeth or heavy wear on any of these parts usually means the set should be replaced together. Matched gears and bearings give the most consistent results.
Keep the work clean and label the parts as they come out. Small debris can damage new gears, so flush the carrier and use fresh gear oil when the rebuild is finished.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 2009155 |
| UPC | 23913133269 |
| Axle | Dana Super 44 |
| Differential type | Open, 30 spline |
| Position | Rear axle |
| Included | Differential and side gears, thrust washers, cross shaft, hardware |
Vehicle fitment
It fits the 2007-2013 Jeep Wrangler (JK), including the Rubicon, Sahara, Sport and Unlimited versions of those years.
The list stops at 2013, so 2014-2018 Wrangler JK models are not covered. The earlier TJ, LJ and YJ Wranglers are not covered either. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The spider and side gears have to be installed with the thrust washers and cross shaft in the sequence the case calls for, and the gear backlash must be checked before the carrier goes back into the axle. Set backlash with the proper tools, because an incorrect setup can damage new gears quickly.
What’s included
Differential and side gears, thrust washers, cross shaft and hardware.
Not included: The differential case and the ring and pinion are not part of this kit.









