Overview
The CORE 44 rear axle housing, part number 67-2052TJR, is a bolt-in replacement for the rear axle of the 1997–2006 Jeep Wrangler TJ and the 2004–2006 LJ Wrangler Unlimited.
The CORE 44 is built on a Dana 44 gear design, made to handle loads that would normally bend a stock Dana 35 or a stock or Rubicon Dana 44. It accepts stock Dana 44 ring and pinion sets, axle shafts and aftermarket lockers, and it is to be used with JK ring and pinion gears.
Key features
- Bolt-in replacement with a bare axle housing
- Dana 44 gear design, with use of JK ring and pinion gears
- Three-inch diameter, heavy-duty DOM axle tubing
- CNC-formed brackets for bolt-in installation
- Spanner nuts for easy backlash adjustment
- Heavy-duty forged bearing caps
- Includes a G2 differential cover
Bare housing build-up
A bare axle housing arrives without its working components, so it has to be built up before it can carry load. The ring and pinion, axle shafts, bearings, locker and brake parts all need to be fitted and set correctly. Most of the setup happens in the carrier, where pinion depth, bearing preload and backlash all interact.
The differential cover and brackets should be fitted with fresh gaskets and clean sealing surfaces to keep the lubricant inside. Wheel bearings, seals and brake hardware are often replaced at the same time as a housing swap, because they are disturbed during installation. Once the axle is back in service, check for leaks and retighten fasteners after the first few drives.
- Set pinion depth before fitting the carrier
- Check bearing preload and backlash with the spanner nuts
- Fit fresh gaskets and clean the sealing faces
- Recheck the fasteners after the first few drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 67-2052TJR |
| UPC | 631410128642 |
| Position | Rear |
| Housing type | CORE 44, Dana 44 |
| Tube diameter | 3 inches, heavy-duty DOM tubing |
| Installation | Bolt-in |
Vehicle fitment
It fits the 1997 to 2006 Jeep TJ Wrangler and the LJ Wrangler Unlimited, covering 1997 to 2006 TJ models and 2004 to 2006 LJ models.
JK, JL and YJ Wranglers, and Jeep models other than the TJ and LJ, are not covered by this housing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The housing comes bare, so the ring and pinion, axle shafts and differential components must be installed on it separately. Backlash is set with the spanner nuts, and the carrier pre-load is set by the adjuster system, so the setup should be checked after installation.
What’s included
One bare rear axle housing with the G2 differential cover, part 67-2052TJR.
Not included: the ring and pinion gears, axle shafts and lockers, which are fitted separately.


















