Overview
The Fabtech Uniball Upper Control Arm Set, part number FTS26045, is a front upper tube arm set for the 2007 to 2009 Toyota FJ Cruiser. It fits the Base, TRD Special Edition and Trail Teams Special Edition trims. The arms replace stock ball joint arms that can wear under hard off-road use.
The tubing is 4130 chromoly with a 1.250 in. outside diameter. The uniball is an American made 1 in. FK stainless PTFE-lined bearing, and its 17-4 stainless steel heat-treated pin fits the factory ball joint taper without spindle modification.
Misalignment spacers made from 17-4 stainless steel keep the 1 in. uniballs from binding through the full travel range. The urethane frame-side bushings reduce road noise and are designed for longevity.
The arms add caster for on-road stability with larger tires and suit both stock and lifted suspensions. Confirm caster specifications and load limits before setting the arms up for heavy loads.
Key features
- 4130 chromoly tube, 1.250 in. outside diameter
- American made 1 in. FK stainless PTFE-lined uniball
- 17-4 stainless heat-treated uniball pin
- 17-4 stainless misalignment spacers
- Urethane frame-side bushings
- Additional caster
Off-road arm wear signs
Upper control arms carry the axle’s position through the suspension’s travel, so a worn pivot shows up as a change in how the vehicle tracks. On a truck that sees hard off-road use, the stock ball joint can loosen first, which is why many owners move to a uniball design. The joint geometry matters, because it sets how the axle moves when the wheels cycle up and down.
A tube arm with a uniball needs regular checks for play and for binding at full articulation. Frame-side bushings wear more slowly than ball joints but still need inspection, especially after tire or lift changes that alter arm angles. Larger tires put more load on the arms, so inspection should be more frequent on a heavily used vehicle.
- Check the uniball for play by hand
- Inspect the tube welds for cracks
- Look at the frame bushings for splits
- Recheck caster after tire changes
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS26045 |
| Position | Front upper |
| Type | Tube, Uni-Ball joint |
| Tube | 4130 chromoly, 1.250 in. OD |
| Uniball | 1 in. FK stainless, PTFE-lined |
| Frame bushings | Urethane |
| Fit | Direct fit |
Vehicle fitment
It fits 2007 to 2009 Toyota FJ Cruiser models, including Base, TRD Special Edition and Trail Teams Special Edition trims.
Other Toyota models, and FJ Cruiser years outside 2007 to 2009, are not in this fitment. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fit the pins into the factory ball joint tapers, which Fabtech says needs no spindle work. Confirm the arm layout against your FJ Cruiser before starting the job.
What’s included
The Uniball upper control arm set.









