Overview
The Fabtech 6 Inch Spindles, part FABFTS26075, are front spindles that raise the front height for added ground clearance. They use a one-piece cast design.
They install without welding, accept the factory ball joints, and fit stock tires and wheels. Confirm the year, model and chassis match your vehicle before ordering.
A front height change also changes the steering geometry, so a front alignment is normally needed after a spindle lift. Plan for alignment after installation.
Key features
- 6 inch height increase at the front
- Increased front end ground clearance
- Designed for a stock-like ride
- One-piece cast design
- No-weld installation
- Accepts factory ball joints
- Accepts stock tires and wheels
Before a spindle lift
Raising the front with spindles changes the angles of the front driveline, the steering linkage and the brake lines. Steeper angles can increase wear on CV joints and ball joints, and longer brake lines may need inspection for strain. Tire clearance also changes, so check for rubbing at full steering lock and under compression after the lift is complete.
Keeping the factory ball joints and stock wheels helps preserve the original setup, but the front end still needs a full alignment and a check of related parts. Look at sway bar links, steering components and bushings during installation, since a front height change can affect how these parts load up on the road.
- Check CV joint and driveline angles
- Inspect brake lines for strain
- Check tire clearance at full lock
- Align the front end after installation
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABFTS26075 |
| Position | Front |
| Lift | 6 inch |
| Construction | One-piece cast |
| Installation | No welding required |
| Ball joints | Accepts factory ball joints |
Vehicle fitment
Confirm the year, model and chassis match your vehicle before ordering.
Confirm the spindle matches your vehicle’s year, model and trim before ordering.
Installation notes
The spindles install without welding and reuse the factory ball joints. A front-end alignment is normally needed after a height change.
What’s included
Front spindles only.









