Overview
The Fabtech K4159 is a 3-inch Sport lift kit with shock extensions for 2020 to 2026 Jeep Gladiator models. The Sport kit offers more ride height and improved suspension performance at a moderate price, and installation takes a couple of hours.
The front uses American made dual rate coil springs. The first stage of the spring gives a soft ride with room to extend for extra travel, and the second stage carries the vehicle’s payload and absorbs large impacts at higher speeds. The rear receives coil spring spacers that keep the factory ride and load carrying capacity, and they add a 1-3/4 inch height to help level the stance.
Key features
- 3-inch lift height with dual rate American made front coil springs
- Extended travel from the first spring stage for off-road use
- Rear coil spring spacers of 1-3/4 inch
- Four bump stop extensions that use the factory bump stops
- Extended front and rear sway bar links with urethane bushings
- Sway bar links that stay within the factory operating planes
- Includes shock extensions.
Driveline and alignment after lifting
A lift changes the angles the driveline and suspension operate at, so it helps to inspect them after the job is done. Extended sway bar links keep the bars within their operating range, which reduces the bind that can occur at full extension. Check that the links move freely through the full travel range.
Dual rate springs give a softer first stage for daily driving and a firmer second stage when the vehicle carries load. Pay attention to how the truck rides when loaded with gear or a trailer. Re-check the alignment once the new height has settled, since the front geometry can shift slightly during the first drives.
- Check driveline angles after the install
- Re-torque bolts after the first few drives
- Confirm clearance at full steering lock
- Recheck alignment once the height has settled
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABK4159 |
| Lift height | 3 inches |
| Lift height range | 0 to 3.5 inches |
| Front springs | Dual rate coil springs, American made |
| Rear spacer height | 1-3/4 inches |
| Bump stop extensions | Four |
| Sway bar links | Extended front and rear, urethane bushings |
| Shocks | No shock absorbers are included with this kit. |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2020 to 2026 Jeep Gladiator models in the 80th Anniversary, High Altitude, Launch Edition, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport versions.
Wrangler models do not fit this kit, and Gladiator models from before 2020 are not covered. Check your vehicle’s year, model and trim before ordering.
Installation notes
The extended sway bar links keep the bars within their operating planes and prevent over-center bind at full extension travel. A 3-inch lift changes suspension geometry, so check the driveline angles and the alignment once the install is complete. Fabtech gives a couple of hours for the job.
What’s included
The kit includes the dual rate front coil springs, the 1-3/4 inch rear coil spring spacers, four bump stop extensions and the extended front and rear sway bar links with urethane bushings.
Not included: Shock absorbers. Not included with this kit.













