Overview
The Fabtech K4177M is a Crawler long arm lift kit with Stealth shocks at the front and rear. It is sized as a 5-inch kit for 2020 to 2026 Jeep Gladiator trucks and has a lift height range of 4 to 5.5 inches. It is designed for experienced drivers who want a suspension that works without ongoing fabrication.
The long arm geometry is the core of the design. Fabtech says its link arm placement gives the Gladiator smooth handling across the full travel range. The lower link arms are 2 inches outside diameter with a .313 wall, and the joints are Fabtech 5 Ton units that Fabtech says carry a lifetime guarantee against wear. The adjustable rear links attach to the factory frame and axle brackets.
Key features
- 5-inch long arm Crawler design
- Stealth shocks at the front and rear
- Full width front crossmember spanning frame rail to frame rail
- Lower link arms of 2-inch OD, .313 wall tubing
- 5 Ton joints throughout the link arms
- Adjustable rear links on factory brackets
- Coil springs at the rear provide the lift.
Long arm geometry basics
Long arm kits use arms that run from the frame to the axle, which controls the axle position as the suspension moves. Because the arms replace the factory control arm positions, the pivot points and bushings take a different load. Inspect the bushings and joints at routine service, especially after rough terrain or hard landings.
Coil springs at the rear work with the long arm design to keep the ride consistent. The adjustable rear links let you dial in pinion angle, which affects driveline vibration. Use a helper for alignment checks and take measurements both before and after adjusting the links so you can compare the results.
Wheel and tire changes affect how the arms and links move, so check clearance at full travel after any size change. Keep fasteners torqued to specification, and recheck them after the first few trips. Shocks at the front and rear should be inspected when the suspension is serviced.
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABK4177M |
| Lift kit size | 5 inches |
| Lift height range | 4 to 5.5 inches |
| Front shocks | Stealth |
| Rear shocks | Stealth |
| Rear lift component | Coil spring |
| Lower link arms | 2-inch OD, .313 wall tubing |
| Fitment type | Direct fit |
Vehicle fitment
The kit fits 2020 to 2026 Jeep Gladiator models in the 80th Anniversary, High Altitude, Launch Edition, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport versions.
2019 and 2023 and later Gladiator models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the long arms replace the factory control arm positions, an alignment and a driveline angle check should follow installation. Check the adjustable rear links and the front link arms for clearance at full travel once the kit is in.
What’s included
The kit includes the long arm link set, the full width front crossmember, the adjustable rear links, the Stealth shocks at the front and rear, and the rear coil springs.













