Overview
The Fabtech K4177DL is a 5-inch Crawler long arm lift kit with Dirt Logic 2.25 shocks for the 2020 to 2026 Jeep Gladiator. The Crawler is a long arm system designed to work without the fabrication and ongoing maintenance that some long arm setups need. The lift height range is 4 to 5.5 inches, and it covers 80th Anniversary, High Altitude, Launch Edition, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport versions.
Front link arms mount to a full width crossmember that spans frame rail to frame rail. The crossmember sets the arms at their intended geometry and adds strength to the Gladiator frame for hard off-road use. The adjustable rear links use the factory frame and axle brackets, which keeps installation straightforward.
Key features
- 5-inch long arm lift for the Gladiator
- Full width front crossmember, frame rail to frame rail
- Lower link arms of 2-inch OD, .313 wall tubing
- Upper and lower link arms with Fabtech 5 Ton joints
- Adjustable rear links on factory brackets
- Dirt Logic 2.25 shocks at the front and rear
- Rear coil springs are part of the lift.
Long arm geometry and driveline
Long arm suspensions keep the axle located with arms that run from the frame to the axle, so the axle travels in a controlled arc. Because the arms replace the factory control arm positions, the link geometry sets how the axle moves through its travel. Keeping the front crossmember and link arms square to the frame helps the suspension behave predictably on rough ground.
Driveline angles change when the axles move to a new height, and vibration often shows up as a first sign. Check U-joint angles after installation and watch for buzzing at highway speeds. Worn joints in the link arms and steering components are easier to replace before a long trip than after one.
- Check driveline angles at both ends after installation
- Inspect link arm joints for play during regular service
- Look for rubbing at full suspension travel
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABK4177DL |
| Lift kit size | 5 inches |
| Lift height range | 4 to 5.5 inches |
| Front shocks | Dirt Logic 2.25 |
| Rear shocks | Dirt Logic 2.25 |
| Rear lift component | Coil spring |
| Lower link arms | 2-inch OD, .313 wall tubing |
| Joints | 5 Ton joints with a lifetime guarantee. |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2020 to 2026 Jeep Gladiator models in the 80th Anniversary, High Altitude, Launch Edition, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport versions.
Gladiator model years outside 2020 through 2026 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A long arm kit replaces the factory control arm locations, so a wheel alignment and a driveline angle check belong after installation. The adjustable rear links and the front link arms should be checked for clearance at full travel once the kit is in.
What’s included
The kit includes the front link arms, the full width front crossmember, the adjustable rear links, Dirt Logic 2.25 shocks at both ends and the rear coil springs.













