Overview
The Fabtech K4100 is a 3 inch spacer system with shock extensions for the 2018 Jeep Wrangler JL Unlimited four-door, with the 3.6L V6 engine. It keeps the factory coil springs and shocks, and adds spacers and extensions to lift the vehicle and make room for oversized tires.
Fabtech offers it as an economical way to lift a Jeep JL while keeping the factory ride. The system includes the heavy-duty components needed for a quick installation.
Key features
- Front steel and rear billet coil spring spacers
- Shock extensions that keep the stock shocks
- Four bump stop extensions that control travel within factory specifications
- Extended front and rear sway bar links with urethane bushings
- Extended rear sway bar links to prevent the bar from going over center
- Heavy duty rear track bar bracket that recenters the axle
- Retains the factory roll center at the higher ride height
- It fits 35 inch tires with minor trimming, or 37 inch tires with cutting.
Before you buy
Spacer lifts change the geometry the factory suspension was tuned for, so it helps to think through the whole setup before ordering. Coil spring spacers raise the body while the stock springs stay in place, which keeps the ride close to factory. Shock extensions lengthen the existing mounts so the original absorbers can reach the new height. That keeps the job simpler, but the factory shocks then carry the extra travel, so their condition matters.
Steering and driveline angles change at a higher ride height, so plan on an alignment and a driveline check once the lift is in. Larger tires add weight and can rub at full steering lock, so a clearance check is worth doing before the first trail run. Look for worn bump stops, cracked sway bar bushings and leaking shock bodies at each service interval.
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K4100 |
| UPC | 700008517311 |
| Lift height range | 2 to 3 inches |
| Engine | 3.6L V6 |
| Shocks | Stock shocks retained with extensions |
| Front spacer | Steel |
| Rear spacer | Billet |
| Position | Front and rear |
Fabtech lists four shock options for this spacer system: the shock extensions that keep the stock shocks, stealth monotube shocks, Dirt Logic 2.25 non-reservoir shocks and Dirt Logic 2.25 remote reservoir shocks. This K4100 version uses the shock extensions.
The shock extensions retain the stock shocks, so the factory shock absorbers stay in the system.
Vehicle fitment
It covers the 2018 Jeep Wrangler JL Unlimited four-door models across the Unlimited trim levels. Two-door JL models are not covered.
The 2018 JL is the listed year. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Standard fenders need minor trimming for 35 inch tires, and high clearance fenders need cutting for 37 inch tires. An alignment is needed after installation.
What’s included
Included: front and rear coil spring spacers, bump stop extensions, extended sway bar links, a heavy duty rear track bar bracket, and shock extensions that retain the stock shocks.












