Overview
The Fab Fours Overland Rack Single Cross Member (JTOR-03-1) is an additional cross member for the Fab Fours Overland Rack, made for the 2020–2026 Jeep Gladiator (JT). It adds a bar to the rack floor to help support more of the rack’s surface from end to end.
The rack part it is required for is JTOR-01-1. It is made from 11 GA U.S. steel with a 2-stage black powder coat finish and weighs 10 lb.
Key features
- Single accessory cross member for the rack
- Helps create total roof and floor coverage
- Multiple mounting points, multiple tie-down points and integrated pod mounts on the rack system
- Expandable design
- Made in the USA.
Choosing a cross member layout
Where a cross member sits changes how the rack floor carries weight. Spread bars evenly so the load does not concentrate in one span, and keep clear gaps where you need access to fixings or tie-downs. Think about what you carry most often, since a layout that suits bulky gear may differ from one that suits long, narrow items.
Once fitted, leave the bars undisturbed for the first few trips and then check the fixings. Keep the finish intact by avoiding dragging hard items across the surface, and remove debris from the joints so moisture does not sit against the steel.
- Spread bars evenly across the floor
- Keep access to fixings and tie-downs
- Match the layout to your usual gear
- Keep joints free of debris and moisture
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FFIJTOR-03-1 |
| Model number | JTOR-03-1 |
| Component | Single cross member for the Overland Rack |
| Material | 11 GA plate U.S. steel |
| Finish | 2-stage black powder coat |
| Weight | 10 lb |
| Origin | Made in the USA |
Vehicle fitment
It is made for the 2020–2026 Jeep Gladiator (JT) in the 80th Anniversary, Altitude, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport trims.
Wrangler JL and older Jeep models are not covered by this fitment. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install the Overland Rack (JTOR-01-1) first, since this cross member is required for it. Plan the fitting, including tools and steps, before you start.
What’s included
Check the package contents against your installation before starting, including the rack, mounting hardware and any other cross members you need.
Not included: the Overland Rack (JTOR-01-1) and any other cross members needed to build a solid floor.









