Overview
The ARB RD117 is an air activated selectable locking differential for Dana 44 axles with 30 splines. It fits gears at a 3.73 ratio and numerically lower.
An ARB Air Locker uses air pressure to lock both axles. With the locker engaged, an open differential works as a full spool, sending power to both wheels when traction is poor. The locker operates with a simple push button and needs an ARB onboard air compressor, which is sold separately.
Key features
- Air activated selectable locker
- For Dana 44 axles with 30 splines
- For use with 3.73 and down gears
- Converts an open differential to fully locked or spool
- Simple push button operation
Planning an air locker install
Fitting an air locker changes how the axle carries load, so plan the work before the housing is opened. The locker is only one part of the setup. The air supply, the control switch and the air line all need a clear route that stays away from suspension travel, exhaust heat and moving parts. Many owners mount the compressor in a protected spot and run the line through existing grommets where possible, which keeps the install neat and easier to service later.
Gear work usually comes first. The locker is installed in the carrier, and the ring and pinion mesh and pinion preload are set afterward, which is why gear shops handle most of these jobs. If the axle ratio is changed at the same time, the locker, gears and bearings should be checked together so the setup works as one unit before the vehicle goes on the trail.
- Route the air line away from heat and sharp edges
- Check carrier bolts and torque after the first few trail runs
- Test engagement on level ground before relying on the locker
- Keep spare fittings and a small air leak check kit on hand
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD117 |
| UPC | 881348006783 |
| Axle type | Dana 44 |
| Axle spline | 30 splines |
| Gear ratio | 3.73 and down |
| Differential type | Air activated selectable locker |
| Operation | Push button |
Vehicle fitment
It is built for Dana 44 axles with 30 splines and gears at 3.73 and down. Match the axle spline count and gear ratio to your housing before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear shops usually install air lockers, because the gear mesh and pinion preload have to be set after the locker is fitted. Plan the air line route and the compressor location before installation.
What’s included
The air locking differential.
Not included: the ARB onboard air compressor, which is required to activate the locker.












