Overview
The Detroit Locker 913A582 is a TrueTrac limited-slip differential for a rear Nissan M226 D44 axle with 32 splines. It is an all gear driven, clutchless design, so torque moves to the wheel that still has grip without relying on clutch packs that wear over time. Power transfers automatically from a slipping wheel to the non-slipping wheel.
Drivers who want limited-slip action without clutch wear get that from this gear-driven design. Match the axle type and spline count to your housing before ordering.
Key features
- Clutchless, all gear driven limited-slip design
- Moves power automatically from a slipping wheel to the wheel with grip
- No clutches to wear out
- Nissan M226 D44 axle type with 32 splines
- Rear axle location
Gear-driven limited-slip basics
A limited-slip differential sends torque across the axle when one wheel loses grip, which helps the truck keep moving on loose dirt, mud, ice and rock. Clutch-pack units rely on friction plates that wear and need adjustment over time. A gear-driven design uses the gears themselves to bias torque, so there are no friction plates to replace on a routine schedule. This matters most on trails where one wheel regularly lifts or climbs.
Before installing any limited-slip unit, look at the rest of the axle. Ring and pinion gears, bearings, the pinion seal and axle shafts are commonly replaced or inspected at the same time, since a new carrier puts new loads through them. Axle shafts need to match the spline count of the carrier, so confirm that before buying shafts. Gear mesh should be set by a qualified tech and checked for a proper contact pattern.
- Inspect the pinion seal for leaks
- Check axle bearings for play
- Match axle shaft spline count
- Set ring and pinion backlash carefully
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 913A582 |
| UPC | 70000341652 |
| Differential type | Limited slip assembly |
| Design | All gear driven, clutchless |
| Axle type | Nissan M226 D44 |
| Axle spline count | 32 splines |
| Axle location | Rear |
| Axle manufacturer | Other |
Vehicle fitment
The rear axle is a Nissan M226 D44 with 32 splines. Match the year, model and trim to your truck before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear-driven differentials are usually fitted by a professional, who sets the ring and pinion mesh and runs the break-in. The axle shafts must match this unit’s 32-spline count.
What’s included
Check the package contents against your installation before starting.










