Overview
The Dana Spicer 34367 is a differential spider gear for the Dana 60, fitting the 1979-1980 Dodge W300 and the 1981-1993 Dodge W350.
A spider gear is one of the small gears inside a differential carrier that lets the two wheels on an axle turn at different speeds. This part is a differential spider gear for the Dana 60 axle, identified by part number 34367.
No position, quantity or material is stated, which means the part number should be checked against a Dana parts diagram for your axle before ordering.
The Dana 60 is a heavy-duty axle, which fits the W-series trucks on the list. The two entries cover different model years, 1979-1980 for the W300 and 1981-1993 for the W350, and the gear itself is a single differential part rather than a complete carrier or axle assembly.
Before ordering, match the Dana 60 axle tag, the truck model and year, and the number stamped on the gear against your axle.
Key features
- Differential spider gear for the Dana 60
- Dana Spicer part 34367
- Fits Dodge W300 and W350 trucks
- Direct fit.
Before opening the carrier
Because the gear sits inside the carrier, replacing it is a carrier-level job. Most of the work is removing the cover, pulling the pinion shaft and cross pin, and rotating the side gears out of the way. Plan on a clean bench, fresh gasket material and the correct gear oil for the axle before closing it up.
Spider gears wear at the back faces where they bear against the side gears, and at the bore where the cross pin sits. Clicking on tight turns, a wheel that spins on pavement, or metal flakes on the magnet are common signs the internal set is worn. Look at the side gears and the pinion gear for matching wear while the carrier is open.
Gears are usually replaced as a matched set, since a new spider gear meeting worn side gears can load unevenly. Check the gear backlash and tooth contact after reassembly, and re-torque fasteners after the first few drives.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 34367 |
| UPC | 23913138370 |
| _pn | 34367 |
| Part type | Differential spider gear |
| Axle | Dana 60 |
| Fit type | Direct fit (Dana Spicer) |
Check the spline count, quantity per package, position and material against your axle before ordering.
Vehicle fitment
It fits two four-wheel-drive Dodge pickups, the W300 and the W350, in the years below.
The manufacturer fitment list for part 34367 covers: 1979–1980 Dodge W300; 1981–1993 Dodge W350.
Not listed: other Dodge trucks, other model years of the W-series and any other make. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A spider gear lives inside the differential carrier, so the carrier must be opened to replace it. Replacing only one gear in a worn set is generally not advised.
What’s included
- One differential spider gear (quantity not stated)












