Overview
The Jeep 68004075AA is a factory style differential side gear kit for the Dana 30 front axle of the 2007-2017 Jeep Wrangler (JK), in 2-door and 4-door models. Side gears are the two gears inside the front differential that connect to the axle shafts.
The part carries the Jeep name and is a factory style replacement. Use part number 68004075AA when matching it to a parts diagram.
It fits the whole Wrangler (JK) model across those years, including the Unlimited versions.
Side gear work is usually part of a front differential repair, when the spider gears, thrust washers and bearings are often replaced as well. Confirm the contents against a Jeep parts diagram before starting.
The Wrangler (JK) front axle is a Dana 30, and this kit fits both the 2-door and the longer 4-door bodies. Vehicles with a different front axle, such as after an axle swap, need a different part. Confirm the axle type before ordering.
Key features
- Differential side gear kit
- Dana 30 front axle
- 2-door and 4-door models
- Factory style replacement part
- Fits 2007-2017 Jeep Wrangler (JK) models.
Before opening the differential
Opening the front differential is a bigger job than swapping a belt or a filter. Side gears sit with the spider gears and carrier components, and the carrier must be removed and set up correctly. Clean the housing, mark the bearing caps, and keep parts sorted by position so they go back where they came from.
Inspect the mating gears, spider gears, thrust washers and bearings while the carrier is open. Chipped teeth, scoring or heavy polishing point to wear, and the parts that mesh with them usually need attention at the same time. Replacing gears in matched sets helps keep the backlash and contact pattern correct.
Gear lash and bearing preload are set during assembly and affect noise and durability, so setup should follow a service manual and be checked with the carrier installed. Fluid should be the specified type and level after the work. If you hear whine or clunking after installation, stop and re-check the setup before driving further.
Specifications
| Brand | Jeep |
|---|---|
| Part number | 68004075AA |
| UPC | 68004075AA |
| _pn | 68004075AA |
| Part type | Differential side gear kit |
| Axle | Dana 30 front |
| Body styles | 2 and 4-door models |
| Fit type | Direct fit (Jeep) |
Check the tooth count, spline count and kit contents against your existing gears before installing.
Vehicle fitment
The 68004075AA is a direct fit for the 2007-2017 Jeep Wrangler (JK), including Unlimited versions. Because it is specific to the front Dana 30, fitment is by model and years rather than trim.
The manufacturer fitment list for part 68004075AA covers: 2007–2017 Jeep Wrangler (JK).
Not listed: the 2018 Wrangler (JK), the Wrangler (JL), and earlier Wranglers such as the TJ and YJ. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The side gears sit inside the front differential carrier, so replacing them means opening the front differential. Verify the front axle is a Dana 30 before ordering.
What’s included
- Differential side gear kit (contents not itemized)









