Overview
The Detroit Locker 913A611 is a rear TrueTrac limited slip differential for the Toyota 8 Inch axle with 30 splines, for 4 Cyl. applications. The TrueTrac is a gear-driven unit with no clutch packs, so there are no clutches to wear out over time. When one rear wheel loses grip, torque moves across to the wheel that still has traction, which is how a limited slip helps a vehicle recover from a slipping position.
Eaton is named as the maker of the TrueTrac under the Detroit Locker brand, and part number 913A611 identifies this exact rear unit. Use the part number and axle details below when comparing it with other Detroit Locker carriers.
Key features
- Gear-driven, clutchless TrueTrac design
- Moves torque from a slipping wheel to the wheel with traction
- Limited slip assembly for rear Toyota 8 Inch axles
- Fits a rear Toyota 8 Inch axle with 30 splines
Choosing a rear carrier
Choosing a replacement carrier comes down to matching the housing, spline count and gearing to the vehicle. A limited slip is only useful when it fits the rear end it was built for, so measurement comes before purchase. Gear-driven designs avoid clutch wear, which makes them a steady choice for drivers who want traction without periodic clutch service.
Related parts are often replaced alongside the carrier. Axle shafts, bearings, seals and the cover gasket are commonly inspected during the same job, and fresh gear oil should go in once the carrier is set. A specialist shop can confirm ring and pinion mesh, so the gearing runs quietly from the start.
- Measure housing width and spline count
- Inspect axle shafts and bearings
- Replace seals that show any leakage
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 913A611 |
| UPC | 700003722111 |
| Axle location | Rear |
| Axle type | Toyota 8 Inch |
| Axle spline count | 30 splines |
| Differential type | Limited slip assembly |
| Popular axle manufacturer | Toyota |
Vehicle fitment
It is identified for a rear Toyota 8 Inch axle with 30 splines. Confirm axle housing and spline count, along with year, model and trim, before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting a differential like this means removing the existing carrier and setting ring and pinion mesh and bearing preload, so a qualified drivetrain shop should handle the job. Check gear contact and preload before the vehicle returns to the road.
What’s included
The unit is the TrueTrac differential assembly under part number 913A611. Confirm whether ring gear, pinion or bearings are needed for your build.






