Overview
The Detroit Locker Chrysler 8.25 29 Spline TrueTrac, part number 912A553, is a rear limited slip differential for Chrysler 8.25-inch axles with 29 splines. It is a gear driven unit that moves torque to the wheel with traction when the other wheel slips.
The TrueTrac design has no clutch packs, which the manufacturer presents as a dependable, long lasting limited slip. For Chrysler rear axles, the 29-spline count is the key measurement to match.
Key features
- Gear driven limited slip action
- No clutches to wear out
- Rear axle location
- Chrysler 8.25-inch axle type
- 29 axle splines
Things to check before installing
A Chrysler 8.25-inch housing is sized around its own carrier, so the unit must match both the axle size and the 29-spline count. Before work starts, measure the housing bore and count the splines on the axle shafts. These checks take little time and prevent a carrier from being ordered for the wrong housing.
Gear mesh and bearing preload are set during installation, and both affect noise and wear. Pinion depth should be set first, then backlash and tooth contact checked. Bearings and the cover are often replaced during a carrier swap, and fresh gasket material helps prevent leaks. Keep the axle supported on stands throughout the job.
Off-road use will show setup errors quickly, so a careful check after the first drive pays off. Listen for whine on coast and under load, and look for oil seepage around the cover and pinion seal. Address any issue before the vehicle goes back on rough ground.
- Measure the housing before ordering
- Set pinion depth before backlash
- Replace the cover gasket during the swap
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 912A553 |
| UPC | 70000325762 |
| Differential type | Limited slip assembly (TrueTrac) |
| Design | All gear driven, clutchless |
| Axle location | Rear |
| Axle manufacturer | Chrysler |
| Axle type | Chrysler 8.25 Inches |
| Axle spline count | 29 splines |
Vehicle fitment
The unit is sized for a Chrysler 8.25-inch rear axle with 29 splines. No model or model years are named for it, so measure the housing and spline count before ordering.
Chrysler housings with a different size or spline count do not match this unit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The carrier fits inside the rear housing and needs gear mesh and bearing preload set correctly. Have a qualified axle shop set the pinion and check backlash before the vehicle sees off-road use.
What’s included
Check the package contents for axle bearings, cover and fasteners before installing.







