Overview
The Detroit Locker 913A589 is a TrueTrac limited-slip differential for a rear Dana 44 axle with 30 splines and a 3.73 down ratio. Its all gear driven, clutchless design shifts torque automatically from a slipping wheel to the one with traction, which helps a vehicle recover when a wheel loses grip.
The TrueTrac has no clutches to wear out, which suits owners who want limited-slip action without clutch upkeep. Match the Dana 44 axle, 30-spline count and 3.73 down ratio against your current axle before ordering.
Key features
- Clutchless, all gear driven limited-slip design
- Transfers power automatically from a slipping wheel to the one with grip
- No clutches to wear out
- Rear Dana 44 axle with 30 splines
- Ratio designated 3.73 down
Gear ratio and setup
Ratio choice changes how the engine and tires work together. A numerically higher ratio gives more pulling force at low speed, while a lower ratio favors highway cruising. Tire diameter, transmission gearing and intended use all affect which ratio suits a particular truck, so the decision concerns the whole drivetrain, not the axle alone.
A limited-slip carrier also depends on correct pinion depth and backlash. Those settings are usually set by a gear shop with the proper tools, and they matter for quiet operation and gear life. When the carrier is out, inspecting the bearings and axle seals is a sensible step.
- Confirm the axle shaft splines match the 30-spline count
- Have pinion depth and backlash checked by a gear shop
- Replace worn carrier bearings while the carrier is out
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 913A589 |
| UPC | 70000368614 |
| Differential type | Limited slip assembly |
| Design | All gear driven, clutchless |
| Axle type | Dana 44 |
| Axle location | Rear |
| Axle spline count | 30 splines |
| Ratio designation | 3.73 down |
| Axle manufacturer | Dana |
Vehicle fitment
No vehicle years, makes or models are given. The stated specifications are a rear Dana 44 axle, 30 splines and a 3.73 down ratio, so confirm each against your current axle.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The ratio and spline count must match the ring and pinion and axle shafts already in the housing, so a professional gear setup is the usual route.
What’s included
No hardware or gears come with this unit. Compare the box contents with your installation plan before you start.













