Overview
The Detroit Locker Ford 9 Inch 28 Spline TrueTrac, part number 912A587, is a rear limited slip differential for Ford 9-inch rear axles with 28 splines. It is gear driven and moves torque to the wheel that still has grip.
The TrueTrac has no clutches to wear out, so it gives a long lasting limited slip action. Fit depends on the 9-inch housing and the 28-spline count rather than the Ford name alone.
Key features
- Gear driven TrueTrac limited slip
- Clutchless design, no clutches to wear out
- Rear axle location
- Ford 9-inch axle type
- 28 axle splines
Carrier care and wear signs
A Ford 9-inch carrier carries heavy load through the ring gear and pinion, so bearing condition and gear mesh matter. Worn bearings can change how the gears mesh and make noise under throttle or on coast. Inspect them whenever the carrier is removed, and set preload again if any bearing is replaced.
Gear driven limited slip units have no clutch packs to wear, so service focuses on the lubricant, seals and gear contact. Change the gear oil after the break-in period and at regular service intervals. Look for metal particles in the oil, which can point to gear or bearing wear that needs attention.
Compare the housing and spline count before buying so the unit fits the axle you have. Keep setup measurements on hand, since future service on a 9-inch axle is easier when the original numbers are available.
- Inspect bearings whenever the carrier is out
- Look for metal particles in the lubricant
- Keep setup measurements for later service
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 912A587 |
| UPC | 70000374290 |
| Differential type | Limited slip assembly (TrueTrac) |
| Design | All gear driven, clutchless |
| Axle location | Rear |
| Axle manufacturer | Ford |
| Axle type | Ford 9 Inches |
| Axle spline count | 28 splines |
Vehicle fitment
The unit is for the Ford 9 Inches axle type with 28 splines. No model or years are named, so measure the 9-inch housing and spline count before ordering.
Ford 9-inch housings differ in spline count and gearing, so check both before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rear carrier replacement requires axle shaft removal, ring and pinion setup and bearing preload checks. Use an axle shop familiar with Ford 9-inch housings for the setup.
What’s included
Check the package contents for axle shafts, bearings and the cover gasket before installing.







