Overview
The Detroit Locker 913A481 is a TrueTrac limited slip differential for GM 10 bolt rear axles with 30 splines. Two axle sizes are named, 8.5 inches and 8.6 inches, so measure your axle before buying.
Like other TrueTrac units, this one is all gear driven and clutchless. Torque moves toward the rear wheel with grip, and there are no clutch packs to replace.
Key features
- Gear driven, clutchless limited slip design
- Shifts torque to the rear wheel with traction
- No clutch packs to replace
- GM 10 bolt rear axle, 8.5 or 8.6 inches, 30 splines
- Limited slip assembly
Ring gear and pinion wear
The ring and pinion are the parts that most often need attention in any GM 10 bolt carrier. Tooth contact should be checked during setup, because a poor pattern can cause noise and early wear under load. Limited slip units also depend on clean gear mesh to move torque smoothly, so any roughness during turns is worth investigating before it grows.
When swapping a carrier, it helps to inspect the axle shafts, bearings and seals at the same time. Worn axle bearings can allow play that changes how the gears mesh. Keep the differential cover free of nicks and replace the cover gasket whenever it is opened, since leaks are a common sign that the carrier was disturbed improperly.
- Check for whine under light throttle
- Look for oil seepage at the pinion seal
- Confirm axle bearings are in good shape
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 913A481 |
| UPC | 91304810000 |
| Manufacturer | Eaton |
| Differential type | Limited slip assembly, all gear driven |
| Axle location | Rear |
| Axle type | GM 10 bolt 8.6 inches or 8.5 inches |
| Axle manufacturer | GM |
| Axle spline count | 30 splines |
Vehicle fitment
It fits GM 10 bolt rear axles in the 8.5-inch and 8.6-inch sizes with 30 splines. Measure your axle to confirm which size applies before ordering.
Both sizes are named, so confirm which one your carrier is before you order. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring and pinion backlash and bearing preload in a limited slip carrier must be set correctly, so have a qualified differential shop install it. Work only with the vehicle fully supported.
What’s included
Check the package contents against your installation before starting, since bearings, gaskets and fasteners may need separate purchase.






