Overview
The Detroit Locker 225SL56A is an automatic locker for Ford 10.25 inch and 10.5 inch rear axles with 35 splines. Eaton makes it, and it sends full drive torque to both wheels so the vehicle keeps pulling when one wheel slips in mud, snow or rocks.
The locker releases when the wheels need to turn at different speeds, then locks again under power. Because it covers two housing sizes, measure the axle before choosing this part.
Key features
- Delivers 100% of the torque to both rear wheels
- Keeps both wheels in constant drive
- Automatic speed differentiation when the wheels need it
- 35 spline design
- Covers 10.25 inch and 10.5 inch Ford housings
Before you install
An automatic locker changes how the axle shares torque, so the rest of the drivetrain should be in good shape before it goes in. Worn ring and pinion gears, a leaking pinion seal or tired carrier bearings are often replaced during the same job, since the carrier is already out. Once the unit is set, check gear backlash and bearing preload, because a locker loads the gears differently than an open carrier does.
Driving habits matter as well. Automatic lockers are most noticeable on slippery ground and during low speed turns on pavement, so a gentle break-in on dry roads is a sensible start before heavy trail use. A light clicking when turning is common with this type of locker, but it should ease as the unit settles. Persistent clunking is worth an inspection.
- Replace pinion seal and carrier bearings during the install
- Re-check backlash after the first few trail runs
- Keep tire pressures matched on both rear wheels
- Use the gear oil your axle requires
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 225SL56A |
| UPC | 22500560000 |
| Manufacturer | Eaton |
| Axle manufacturer | Ford |
| Axle type | Ford 10.25 Inches and Ford 10.5 Inches |
| Axle location | Rear |
| Axle spline count | 35 splines |
| Differential type | Automatic locker |
Vehicle fitment
The 225SL56A fits Ford rear axles in the 10.25 inch and 10.5 inch sizes with 35 splines. Fit depends on axle size and spline count rather than on vehicle model.
Measure the housing and count the splines before ordering, since the match is by axle size rather than vehicle model. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Automatic lockers are installed with the ring and pinion, so a professional gear setup and break-in are needed. Use rated stands and never rely on a jack alone under the axle.
What’s included
Check the package contents against your installation before starting the job.






