Overview
The Detroit Locker 912A317 is a TrueTrac limited slip differential for GM 10 bolt rear axles with a 7.5 inch axle type and 28 splines. Eaton carries it under part number EAT912A317. The TrueTrac design is all gear driven and clutchless, so it provides limited slip action without friction clutch packs that wear out over time.
When one rear wheel loses grip, a limited slip differential shifts torque to the wheel that still has traction, which can help a vehicle get moving out of a rut, mud or soft ground. With no clutches, there is no clutch pack to replace.
Key features
- All gear driven, clutchless TrueTrac design
- Moves power automatically from a slipping wheel to the wheel with traction
- No clutch packs to replace
- GM 10 bolt 7.5 inch axle type
- 28 spline axle connection
- Limited slip assembly for the rear axle
Before you buy
Limited slip performance depends on the whole rear assembly working together. The carrier sits inside the housing, so the axle shafts, bearings and seals should be inspected while the cover is off. A worn shaft or seal is easier to replace during the same job than on a later trip. Inspecting the housing for cracks and signs of heat before fitting new gears is also a sensible step.
Gear setup matters as much as the part itself. Pinion depth, bearing preload and backlash all change how the gears mesh, and a carrier set too tight or too loose can make noise or wear early. Tooth contact should be checked after installation, and the fluid should be changed once the break-in period is complete. Keep a record of the setup measurements so future service is faster.
- Inspect axle shafts and seals while the carrier is out
- Check tooth contact after installation
- Change the fluid after the break-in period
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 912A317 |
| UPC | 70000293066 |
| Axle manufacturer | GM |
| Axle location | Rear |
| Axle type | GM 10 bolt 7.5 inches |
| Axle spline | 28 splines |
| Differential type | Limited slip assembly (TrueTrac) |
Vehicle fitment
No vehicle or model years are named for this unit. It is built for a GM 10 bolt rear axle with a 7.5 inch axle type and 28 splines, so it is not a general purpose part.
A different axle type or spline count falls outside this unit’s fit.
Installation notes
Check the 7.5 inch axle type and 28 spline count against your rear housing and axle shafts first, because a mismatch will not seat. Replacing a rear differential assembly calls for gear setup and tooth contact checks, so have a qualified technician install and set up the unit.
What’s included
The unit is the differential assembly. Check the package contents for hardware, gaskets and axle shafts before installing.
Not included: Check whether axle shafts, bearings or installation hardware come with the unit before starting the install.






