Overview
The Detroit Locker 915A387 is a front TrueTrac limited slip differential for Dana 60 front axles with 35 splines. It is an all-gear, clutchless design, so there are no clutch packs to wear, and it shifts torque to the front wheel that still has traction. It comes in 4.10 Down gearing.
Part number 915A387 identifies this front Dana 60 unit, and the UPC is 70000227502. Eaton manufactures the TrueTrac for Detroit Locker.
Key features
- Front Dana 60 TrueTrac limited slip
- Gear-based torque transfer with no clutches
- 35 spline front axle count
- 4.10 Down gearing
Gear ratio and setup
A front limited slip shares the gear set with the rest of the axle, so the ratio has to suit the tires and the drivetrain. A ratio mismatch can make the axle bind on turns, heat up under load or wear the gear teeth faster than normal. Before buying, measure your tire diameter and check the ratio against the gears already in the front housing.
Because a gear-based limited slip has no clutch packs, there is no friction material to replace over time. Wear appears in the gear mesh, pinion bearings and carrier bearings instead. Listen for whine under light throttle, look for leaks at the cover and check for play in the axle shafts after trail use. Keep the gear oil fresh with the right limited slip additive, since it protects the gears during slip.
- Check gear oil level after the first few trail runs
- Inspect front axle seals for leaks
- Recheck pinion preload after any carrier work
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 915A387 |
| UPC | 70000227502 |
| Axle location | Front |
| Axle type | Dana 60 |
| Axle spline count | 35 splines |
| Gearing (title) | 4.10 Down |
| Differential type | Limited slip assembly |
| Popular axle manufacturer | Dana |
Vehicle fitment
It is a front unit for Dana 60 axles with 35 splines. Confirm fit for your vehicle’s year, model and trim before ordering, and match the housing, steering and driveline to your vehicle.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A front Dana 60 carrier change involves gear setup, bearing preload and backlash adjustment, followed by checking the driveline angles. Plan for a shop with front axle experience, since the gear mesh must be right before the vehicle is driven.
What’s included
The unit is the TrueTrac differential for part number 915A387. Check the package contents against your installation before starting, including whether a ring gear, pinion or axle shafts are needed.







