Overview
The Detroit Locker 187C145A is an automatic locker for the Ford 8.8 inch rear axle with 31 splines and a 7/8 cross pin. It sends 100% of the torque to both drive wheels and keeps both wheels in a constant drive mode, while still allowing wheel speed differentiation when required.
The locker is intended for traction in mud, snow, rocks and on the track. It is a rear differential part, sized to a specific axle rather than to a vehicle model.
Key features
- Delivers 100% of the torque to both drive wheels
- Keeps both wheels in a constant drive mode
- Automatically allows wheel speed differentiation when required
- Automatic locker type
- Built for the Ford 8.8 inch rear axle with 31 splines
Before you install
An automatic locker changes how power reaches the wheels on a solid axle. With a standard open differential, the wheel with the least grip gets most of the drive. A locker keeps both shafts turning together under power, so a tire that still has grip can pull the vehicle. Off road that difference shows up on climbs, in soft ground and on uneven rock. On pavement the locker still lets the wheels turn at different speeds through a corner, so the vehicle handles normally.
Because the locker sits in the axle carrier, the rest of the axle matters. Ring and pinion gears, bearings and axle shafts all carry the added load. Many owners who fit a locker also replace worn carrier bearings or check the axle shafts while the housing is open.
- Check ring gear and pinion condition during the install
- Inspect axle shaft splines for wear before fitting
- Replace worn carrier bearings while the housing is open
- Use fresh gear oil suited to locking differentials
Specifications
| Brand | Detroit Locker |
|---|---|
| Manufacturer | Eaton |
| Part number | 187C145A |
| UPC | 70000010132 |
| Axle manufacturer | Ford |
| Axle type | Ford 8.8 inches |
| Axle location | Rear |
| Axle spline count | 31 splines |
| Cross pin | 7/8 |
| Differential type | Automatic locker |
Vehicle fitment
It is sized for the Ford 8.8 inch rear axle with 31 splines. Confirm fit for your vehicle’s year, model and trim before ordering.
Axles with a different spline count or axle size are not covered by this specification. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting an automatic locker means opening the rear differential, so the work usually falls to an axle shop or qualified installer. Confirm the 8.8 inch size and 31 spline count against your axle before starting.
What’s included
The automatic locker unit, part number 187C145A, is the item covered here. Check the package contents against your installation before starting.







