Overview
The Detroit Locker 913A561 is a TrueTrac limited slip differential for Ford 9-inch rear axles with 31 splines, made by Eaton under the Detroit Locker brand.
Its all gear driven design uses no clutch packs, so there is nothing to adjust or replace. Power moves to the wheel that still has grip when the other one slips.
Key features
- Gear driven, clutchless TrueTrac design
- Power moves to the wheel with grip
- No clutch packs to adjust or replace
- Ford 9-inch rear axle, 31 splines
- Complete limited slip assembly
Gear setup and break-in
A limited slip differential depends on precise gear setup. Ring and pinion contact pattern, bearing preload and backlash all affect how smoothly the unit runs and how long the gears last. Setup is usually left to a shop with the right tools, and the installer should confirm each measurement before the cover is sealed.
Gear-driven limited slip units perform best with a lubricant intended for limited slip gear sets. Plan a short break-in period with gentle loading, and check for leaks at the cover and axle seals afterward. Many owners also inspect the fluid after the first few hundred miles of mixed use to catch any early debris.
- Confirm ring and pinion setup before installation
- Use a lubricant suited to limited slip gear sets
- Check cover and seal areas for leaks after break-in
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 913A561 |
| UPC | 91305610000 |
| Manufacturer | Eaton |
| Differential type | Limited slip assembly, all gear driven |
| Axle location | Rear |
| Axle type | Ford 9 inches |
| Axle manufacturer | Ford |
| Axle spline count | 31 splines |
Vehicle fitment
No vehicle years or models are given. This unit is identified by a Ford 9-inch rear axle with 31 splines, so check the spline count and axle size before ordering.
This identification covers 31 splines only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Limited slip gear sets need correct ring and pinion setup, so have a differential specialist install the unit and set preload and backlash. Keep the vehicle stable on stands during the work.
What’s included
Bearings, seals and hardware are not confirmed as included.






