Overview
The Detroit Locker Dana 35 27 Spline 3.54 Up Rear TrueTrac, part number 912A569, is a rear limited slip differential for Dana 35 rear axles with 27 splines and 3.54 Up gearing. Match your ring and pinion ratio to it before ordering.
The unit uses the gear driven TrueTrac design with no clutch packs, so torque shifts to the wheel that has traction when one side slips. Verify the Dana 35 housing and the 27-spline count before buying.
Key features
- Gear driven limited slip action
- Clutchless, no clutch packs to replace
- Rear axle location
- Dana 35 axle type
- 27 axle splines
- 3.54 Up gearing
Setup and gearing notes
Gearing is the core of a carrier swap. A 3.54 Up ratio changes the final drive, so the ring and pinion have to be matched as a pair. Pinion depth and bearing preload must be set before the backlash and tooth contact pattern can be trusted. An axle shop with Dana 35 experience can usually set these faster and with fewer repeat checks.
Gear driven limited slip units suit drivers who want traction without the wear items of a clutch type. The action can feel different on pavement, especially when turning, so spend a short time driving at low speed after installation. Keep the spline count, housing and gearing recorded before any future carrier service.
Axle shafts, seals and bearings are worth inspecting while the carrier is out. Replacing a worn seal during the same job avoids a second teardown later.
- Confirm the ratio before the carrier goes in
- Check pinion depth and preload
- Inspect axle shafts and seals while the axle is open
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 912A569 |
| UPC | 912056900008 |
| Differential type | Limited slip assembly (TrueTrac) |
| Design | All gear driven, clutchless |
| Axle location | Rear |
| Axle manufacturer | Dana |
| Axle type | Dana 35 |
| Axle spline count | 27 splines |
| Gearing | 3.54 Up |
Vehicle fitment
This unit is for Dana 35 rear axles with 27 splines. No model or years are named, so measure the housing before buying.
Dana 35 units with a different spline count or gearing do not match this unit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Carrier replacement requires removing the axle shafts, setting pinion depth, and checking bearing preload and backlash. Have an axle shop set the ring and pinion for the 3.54 Up gearing.
What’s included
Check the package contents for ring gear and pinion before installing, since only the differential assembly is covered.






