Overview
The Detroit Locker 913A315 is a TrueTrac limited slip differential for GM 12 bolt 8.875-inch truck rear axles with 30 splines. The product title also reads 3.73 Up, which indicates gearing of 3.73 and above.
Gear driven limited slip units like this one distribute torque without friction clutches. Because the TrueTrac is all gear driven and clutchless, it moves drive toward the tire that still has grip when the other tire spins, and it has no clutch packs to wear.
Key features
- All gear driven, clutchless TrueTrac design
- Shifts drive from a spinning tire to the one with grip
- No clutch packs that wear out
- GM 12 bolt 8.875-inch truck axle with 30 splines
- Gearing: 3.73 and up
Truck gearing and loads
Gearing on a 12 bolt truck affects how the engine feels when pulling, climbing and towing. Higher ratios like 3.73 and up favor torque at low speed, while lower ratios suit highway cruising. Choose gearing with the tire size and typical load in mind, and keep ring and pinion sets matched as a pair.
A limited slip rear helps when one rear tire loses grip on mud, sand or ice, but it works best when both tires are close in size and wear. Mismatched tires can load the gears unevenly. Use the lubricant type suited to limited slip gears and change it when the carrier is opened.
- Match ring and pinion as a pair
- Keep rear tire diameters close
- Use limited slip gear oil
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 913A315 |
| UPC | 91303150000 |
| Manufacturer | Eaton |
| Differential type | Limited slip assembly, all gear driven |
| Axle location | Rear |
| Axle type | GM 12 bolt 8.875 inches, truck |
| Axle manufacturer | GM |
| Axle spline count | 30 splines |
| Gearing (per title) | 3.73 and up |
Vehicle fitment
It is for a GM 12 bolt truck rear axle, 8.875 inches, with 30 splines and 3.73 and up gearing. Confirm your vehicle’s year, model and trim before ordering.
Check the ring gear diameter, spline count and gear ratio on your axle against these figures. A GM 10 bolt or a different spline count is not the same axle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting ring and pinion backlash and bearing preload in a 12 bolt truck carrier is precise work, so a qualified differential shop should install and set up this unit. Keep the vehicle on stands while working underneath.
What’s included
Bearings, carrier bolts and seals are not confirmed as included. Sort what arrives against your installation steps before starting the job.







