Overview
The 41221 is a 7/16 inch ring gear bolt for Dana 35 and Dana 44 axles. Ten bolts are needed to fasten the ring gear.
The 7/16 inch diameter has to match the holes in your ring gear. The vehicles covered are in the fitment section below.
Ring gear bolt torque and inspection
Ring gear bolts are under constant load as the carrier turns and the gear meets the pinion. Stretched, rusted or damaged bolts can let the ring gear shift, which shows up as noise, vibration or a rattling sound under throttle changes. Because the bolts share the load, a set is only as strong as its weakest fastener.
Before fitting new bolts, clean the threaded holes and check the ring gear and carrier faces for burrs. Work through the bolts in a crossing pattern and use the axle service torque for the final pass. Replacing the full set is usually the safer choice when any bolt shows wear.
- Check the threads for stretching or rust
- Clean the carrier and ring gear faces
- Use the axle service torque in a crossing pattern
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 41221 |
| UPC | 23913140410 |
| Diameter | 7/16 inch |
| Quantity required | 10 |
| Axle | Dana 35 and Dana 44 |
Vehicle fitment
It fits the 1980 and 1983 Jeep CJ7 (Laredo, Renegade), the 1988 to 1989 Comanche (Base, Eliminator), the 1983 and 1985 Scrambler (Laredo, SR), the 2005 Wrangler LJ Unlimited, the 1999 and 2001 Wrangler TJ SE and the 1988 Wrangler YJ S.
The list names only the model years above, so the 1986 CJ7 and the JK Wrangler are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ten bolts are required, so have the full set on hand before you start work on the ring gear.
What’s included
Ten bolts are needed, so confirm the package count against your ring gear before you start work.













