Overview
The Dana Spicer 703034 is a set of ten 1/2-inch ring gear bolts for the front or rear ring gear of the 2014 Jeep Wrangler (JK). The bolts hold the ring gear to the differential carrier, so the set has to be complete and the fasteners have to match the carrier before the gear set goes back in.
It fits the 2014 Jeep Wrangler (JK) with both 2-door and 4-door bodies. Other JK model years and the Wrangler JL are not covered by this set.
Key features
- Set of 10 ring gear bolts
- 1/2-inch size
- Usable at the front or rear ring gear position
- Fits 2014 Jeep Wrangler (JK), 2-door and 4-door models
- Dana says its parts are put through rigorous testing
Ring gear bolt care
Ring gear bolts clamp the ring gear to the differential carrier and carry the torque from the gear set into the carrier. Because the ring gear is loaded every time the vehicle drives, the bolts need to hold the right tension and be free of thread damage. A bolt that stretches, galls or loses clamp load can let the ring gear shift, which affects gear mesh.
Before reinstalling, clean the threads and the bolt holes in the carrier, then check the ring gear face for cracks. Replace the bolts as a full set rather than mixing old and new fasteners. Use a torque wrench set to the axle service figure and follow the tightening sequence for the carrier. After the first drives, check for noise from the gear set and look for any movement at the ring gear face.
Keep the carrier filled to the correct gear oil level, and check for metal debris on the magnet at each service. Early attention to small signs keeps the gear set quiet and the carrier intact.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 703034 |
| UPC | 23913148287 |
| Size | 1/2 inch |
| Quantity | Set of 10 |
| Position | Front or rear ring gear |
| Body style | 2-door and 4-door |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2014 Jeep Wrangler (JK) with both 2-door and 4-door bodies.
Other JK model years, including 2007–2013 and 2015–2018, and the 2018–2022 Wrangler (JL) are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring gear bolts hold the ring gear to the carrier, so tighten them to the axle service specification and use the full set of ten on the ring gear.
What’s included
A set of 10 ring gear bolts, 1/2 inch in size. No other hardware is named.








