Overview
The Currie CE-9113B threaded bung with jam nut is a 1 inch -14 right hand thread weld-in bung. It is made for forged Johnny Joint rod ends or any other 1 inch thread rod end, and it is sold each.
Its hex shape, rather than round, makes bar adjustment easier, and a custom machined jam nut with the same hex size comes with it. The bung is designed to fit into a tube with a 1-1/4 inch inside diameter. No vehicle is named, because this is a custom build component rather than a vehicle-specific part.
Key features
- Right hand 1 inch -14 thread
- Weld-in design for tube builds
- Hex shape for bar adjustment
- Custom machined jam nut included, matching the hex size
- Designed for tubes with a 1-1/4 inch inside diameter
- Sold each
Planning a weld-in bung build
A weld-in bung becomes part of the tube it is joined to, so the build needs planning before any metal is cut. Measure the tube inside diameter first, then confirm the rod end and jam nut match the thread. Mark the weld location on the tube so the bung sits square and the bar can rotate freely.
Thread engagement matters when a rod end is turned onto the bung. Clean the threads before assembly, and make sure the jam nut seats fully against the hex. Recheck the adjustment after the first few trail runs, since heat from welding and movement under load can change how the parts sit.
- Measure tube inside diameter before cutting
- Clean and inspect threads before fitting
- Recheck the jam nut after early use
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9113B |
| UPC | 70000410803 |
| Thread size | 1 inch -14 |
| Thread direction | Right hand |
| Minimum tube ID | 1-1/4 inch |
| Jam nut | Included |
| Sold | Each |
| Fitment | Universal fit |
Vehicle fitment
It is universal fit and is not built for a particular vehicle. Its suitability depends on the tube and rod end used in your build.
Confirm the tube size and the rod end thread match this bung before you weld.
Installation notes
Check that the tube’s inside diameter is at least 1-1/4 inch before welding the bung in. Confirm the rod end is 1 inch -14 right hand so the threads match.
What’s included
One right hand weld-in bung with its custom machined jam nut, sold each.
Not included: the tube and the rod end.








