Overview
The RockJock 1 Inch -14 Threaded Bung With Jam Nut, left hand thread (part number R/JCE-9113BL), is a weld-in bung that accepts a 1 inch -14 rod end, such as a forged Johnny Joint or any other 1 inch thread rod end. It is intended for adjustable bars and links where the rod end is turned in and out to set length.
The bung is hex shaped rather than round, which makes it easier to turn when adjusting a bar. RockJock includes a custom machined jam nut with the same hex size. The bung is designed to fit into tubing with a 1 1/4 inch inside diameter.
Key features
- Hex shape for easier bar adjustment
- Left hand thread
- Custom machined jam nut included
- Weld-in design
- Takes forged Johnny Joint or other 1 inch thread rod ends
Setting and locking bar length
A threaded bung is the adjustable point in a link or bar. Turning the rod end in or out changes the overall length, which lets a builder set alignment geometry without replacing the bar. Once the length is right, the jam nut is tightened against the bung so the rod end cannot back out under load. Recheck the jam nut after each change in setting and after the first few trail outings, since vibration can loosen it.
Because the bung is welded into the tube, the tube wall and the weld quality decide how well the assembly holds up. Inspect the weld for cracks after heavy use and look over the threads for damage before reusing a rod end. Left and right hand threads are common on paired links, so keep track of which bung goes on which end of the bar.
- Mark the thread position before adjusting length
- Retighten the jam nut after every setting change
- Inspect the weld and tube for cracks periodically
- Clean and grease rod end threads before installing
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JCE-9113BL |
| Thread size | 1 inch – 14 |
| Thread direction | Left hand |
| Minimum tube ID | 1-1/4 inches |
| Shape | Hex |
| Jam nut | Included |
| Fitment | Universal fit |
Vehicle fitment
This bung is universal fit and is not built for a particular vehicle. Its use depends on the bar or link it is welded into, so match the thread size and tube diameter to your build.
Installation notes
This is a weld-in bung, so it is welded into the tube. It is designed for a tube with a 1 1/4 inch inside diameter, so confirm your tubing matches before welding.
What’s included
The bung and its custom machined jam nut are included.
Not included: The rod end, such as a forged Johnny Joint, which the bung is designed to accept.








