Overview
The TeraFlex 4107102 is a large weldable threaded insert with a right hand 1-1/4 Inches -12 thread, designed to be welded into control arm length tubing when you build custom links. The large size has a 1-1/2 inch minimum tube ID.
The large insert is sized for TeraFlex’s large Monster ends, which use the 1-1/4 inch 12 tpi thread. The medium and small inserts in the range are sized for 7/8 inch 18 tpi threads and 1-1/8 inch minimum tubing, so choose the size that matches your end before cutting tube.
Key features
- Right hand thread direction
- Large size with 1-1/4 Inches -12 (12 tpi) threads
- Weld-in design for control arm length tubing
- Requires tubing with a minimum 1-1/2 inch inside diameter
Building a custom link
A weldable threaded insert gives a custom link a threaded end that can be adjusted and removed without cutting the tube. Set the insert square to the tube before tacking, then weld evenly around the joint so the thread stays true. Heat from welding can distort the bore, so check that the thread still runs freely before installing the end.
Choose the insert to match the end you are using, both in thread size and direction, and make sure the tube is measured on the inside before cutting. Tubing that is too small will not accept the large insert, and a thread mismatch can make a link impossible to adjust. Plan for a jam nut and check its fit before final assembly.
After welding, inspect the joint for cracks and confirm the thread is clean of spatter. Link ends should be checked for wear at each service, since bent or loose links can change alignment and load the steering and suspension parts beyond their design.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 4107102 |
| UPC | 843885025504 |
| Thread size | 1-1/4 Inches -12 (12 tpi) |
| Thread direction | Right hand |
| Minimum tube ID | 1-1/2 Inches |
| Jam nut | Not included |
| Fitment | Universal fit |
Vehicle fitment
TeraFlex gives universal fit and names no vehicle, so the insert is judged by the link it becomes rather than by a model year.
Measure the tube ID before welding, since the large insert needs at least 1-1/2 inch. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Weld the insert into tubing that meets the minimum, and keep the threaded end square to the tube so the jam nut can seat correctly.
What’s included
One weldable threaded insert, part number 4107102.
Not included: Jam nut.








