Overview
The Crown Automotive 83502855 is a rear slip yoke for the NP231 transfer case. A slip yoke lets the rear driveshaft change length as the suspension moves, and this one is the rear output piece for the NP231.
It fits the 1987–1995 Jeep Wrangler YJ. Confirm the spline count, material and shaft size against your transfer case before installing.
Key features
- Built for the NP231 transfer case
- Rear yoke position
- Crown Automotive part number 83502855
How slip yokes work
A slip yoke allows the rear driveshaft to change length as the axle moves up and down. Its splined shaft slides in and out of the transfer case, and a seal keeps lubricant in while the shaft moves. When the splines are worn, the driveshaft can clunk or vibrate under load, which is often the first sign to check the yoke.
Before buying a replacement, compare the spline count, the shaft diameter and the seal size with the yoke you are removing. Matching those details keeps the driveshaft from binding. Check the transfer case output seal at the same time, since replacing it during the same job saves a second teardown.
- Check splines for wear or pitting
- Inspect the seal for leaks
- Confirm driveshaft slide movement
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83502855 |
| UPC | 848399024852 |
| Transfer case | NP231 |
| Yoke type | Rear slip yoke |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler YJ in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
Not covered on this list: the 1997–2006 Jeep Wrangler TJ, the 2007 and later Wrangler JK, and any Jeep model outside the YJ years. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a rear slip yoke generally means removing the rear driveshaft first. A driveline shop can confirm the spline and seal fit before the driveshaft goes back on.
What’s included
Look over any seal or hardware needed before starting the install.








