Overview
The Omix-ADA 16580.01 is a U-bolt style transfer case output yoke for Dana 18, Dana 20 and Quadra-Trac transfer cases. It has 10 splines and is made for front or rear output.
It is made for the 1966 Jeep CJ3, the 1966–1979 CJ5 and CJ7, the 1966–1975 CJ6, and the 1946–1947 Willys CJ-2. It is built to original specifications and carries a limited five year warranty from Omix-ADA.
Key features
- Compatible with Dana 18, Dana 20 and Quadra-Trac transfer cases
- 10 spline output
- U-bolt style design
- Built to original specifications
Fitting a U-bolt yoke
U-bolt yokes clamp to the output shaft rather than bolting through a flange, so their fit depends on how square and clean the shaft is. Wire brush the shaft and the yoke bore, then check that the yoke slides on without binding. A light coat of anti-seize on the threads, not the splines, helps future service.
On an older CJ, the driveshaft U-bolts and pinion flange often show wear from years of use. Inspect the splines for rounding and the seal surface for grooves. Fit a new seal if the transfer case is leaking, and tighten the U-bolt nuts evenly to the value in your service manual.
- Clean the output shaft before sliding the yoke on
- Inspect splines for wear before reassembly
- Replace leaking seals at the same time
- Tighten U-bolt nuts evenly and recheck after driving
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16580.01 |
| UPC | 804314065942 |
| Transfer case | Dana 18, Dana 20, Quadra-Trac |
| Output | Front or rear |
| Splines | 10 |
| Attachment style | U-bolt |
| Warranty | Limited five year warranty from Omix-ADA |
Vehicle fitment
It fits 1966 Jeep CJ3 (Base); 1966–1979 Jeep CJ5 (Base, Golden Eagle, Renegade); 1966–1975 Jeep CJ6 (Base); 1976–1979 Jeep CJ7 (Base, Golden Eagle, Renegade); and 1946–1947 Jeep Willys CJ-2.
Not covered on this list: Jeep Wrangler and Cherokee models, CJ3 and CJ5 years before 1966, and any model after 1979. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because U-bolts are not included, have the correct U-bolts ready for your driveshaft before fitting the yoke.
What’s included
The yoke is the item supplied.
Not included: U-bolts. Have the correct set ready before fitting the yoke.








