Overview
The Omix-ADA 18676.37 is a front output yoke for the NP231 transfer case, with 26 splines and a strap and bolt style design. It is made for the 1987–1995 Jeep Wrangler YJ.
It is built to original specifications and carries a limited five year warranty from Omix-ADA. The strap and bolt design attaches differently from u-bolt yokes, so match the design to your driveshaft.
Key features
- Front output for the NP231 transfer case
- 26 splines
- Strap and bolt style design
- Built to original specifications
Strap and bolt basics
Strap and bolt yokes clamp the driveshaft yoke with straps tightened by bolts, which spreads the load differently from U-bolt designs. Because of that, a driveshaft set up for one style will not simply swap onto the other. Compare the attachment with your current driveshaft before ordering so the new yoke matches the joint.
On a YJ, the front yoke sees steady torque under off-road loads, so a worn spline or loose strap can cause clunking. Inspect the splines, the seal surface and the strap bolts during driveline service. Tighten the bolts to the value in your service manual and recheck them after the first few drives.
- Compare attachment style with the current driveshaft
- Inspect splines for wear before fitting
- Check strap bolts for looseness during service
- Replace the output seal if it leaks at the yoke
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18676.37 |
| UPC | 804314061524 |
| Transfer case | NP231 |
| Output | Front |
| Splines | 26 |
| Attachment style | Strap and bolt |
| Warranty | Limited five year warranty from Omix-ADA |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler YJ in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
Not covered on this list: the 1997–2006 Jeep Wrangler TJ, the 2007 and later Wrangler JK, and Cherokee XJ models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the spline count on your current yoke against the 26 splines listed here before fitting. Replacing the yoke generally means removing the driveshaft first.
What’s included
The yoke is the item supplied, so gather any seal or hardware your installation needs first.









