Overview
The Omix-ADA 16580.53 is a slip yoke for the NP231 transfer case, and it is a rear slip yoke. Its position reads as front driveshaft at front axle, so confirm the position on your vehicle before fitting it.
It fits the 1987–1995 Jeep Wrangler YJ. It is built to original specifications; check the spline count on your current yoke before fitting.
Key features
- Slip yoke design for the NP231 transfer case
- Built to original specifications
- Limited five year warranty
- Omix-ADA part number 16580.53
Confirming yoke position
A slip yoke at the transfer case must match the driveshaft that runs from it, so the position matters as much as the part number. Front and rear driveshafts have different lengths and ends, and a yoke fitted to the wrong output can bind or vibrate. Before ordering, look at which axle the driveshaft runs to and which case output it enters.
A slip yoke’s splines engage the driveshaft’s sliding joint, so the wear pattern on the old yoke can show whether the position was right. Note the spline count and seal size from the yoke you are removing. Keep the old yoke for comparison until the new part is confirmed.
- Identify the axle the driveshaft runs to
- Compare splines with the old yoke
- Keep the old yoke until fit is confirmed
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16580.53 |
| UPC | 804314061562 |
| Transfer case | NP231 |
| Yoke type | Slip yoke |
| Position | Rear in the short details; front driveshaft at front axle in the position field |
| Warranty | Covered by a limited five year warranty. |
Vehicle fitment
It fits 1987–1995 Jeep Wrangler YJ in Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara and Sport trims.
Not covered on this list: the 1997–2006 Jeep Wrangler TJ, the 2007 and later Wrangler JK, and Cherokee XJ models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the spline count on your current yoke before fitting. Removing the driveshaft is usually the first step.
What’s included
Look over seals and hardware before the install begins.















