Overview
The Crown Automotive Dana 18 or 20 transfer case slip yoke, part number A1445, is a replacement slip yoke with 10 splines and a slinger. It is made for Dana 18 or 20 transfer cases.
A slip yoke joins the transfer case output to the driveshaft and slides in and out to absorb changes in driveshaft length as the suspension moves. It is offered in front or rear U-bolt style.
Key features
- 10 splines
- Includes a slinger
- Front or rear U-bolt style
- Named for Dana 18 or 20 transfer cases
Slip yoke wear and inspection
A slip yoke carries the driveshaft’s changing length and must slide smoothly on the transfer case output spline. When it wears, the typical signs are a vibration under load, a clunk during take-off, or a seal that leaks around the yoke. The splines and the sliding surface should be inspected whenever the driveshaft is removed.
Because the yoke works with the driveshaft and transfer case together, check the companion parts at the same time. Worn output seals, damaged U-bolts and a slinger that has rusted or shifted should be addressed during the job. Clean the spline and sealing surface thoroughly before assembly to prevent premature seal wear.
- Check the splines for wear, rust or uneven marks
- Inspect the seal area for scoring or leaks
- Replace a damaged slinger along with the yoke
- Confirm the U-bolt style before fitting
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | A1445 |
| UPC | 848399050097 |
| Spline count | 10 |
| Slinger | Included |
| Style | Front or rear U-bolt |
| Category | Transfer case yoke |
Vehicle fitment
Dana 18 or 20 transfer cases are units rather than vehicles. Check your transfer case and driveline before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Match the 10 spline count and the front or rear U-bolt style to your transfer case output and driveshaft before fitting. A slip yoke replacement usually requires driveshaft removal, so plan the work around that.
What’s included
Check the package contents against your installation before starting. U-bolts, a seal and other hardware should be confirmed before the slip yoke is fitted.







