Overview
Crown Automotive supplies replacement parts for Jeep vehicles, and this yoke is a drive shaft pinion yoke with part number 4797689.
Crown Automotive marks this yoke as direct fit. No dimensions, material or finish are given, so compare the yoke with your existing one before fitting.
Checking the yoke before fitting
A drive shaft pinion yoke is the splined part that joins the driveshaft to the pinion gear, and its fit determines how the driveline sits. Before installing, look at the splines, the U-joint saddle and the sealing surface for wear, rust or burrs. Small damage on these surfaces can prevent a seal from seating correctly.
Compare the diameter of the new yoke’s bore and splines with the old part if you can measure them, and keep the old pinion nut and any seals only when they are in good condition. Replacing the pinion seal at the same time is common, since the yoke must come off to reach it. Recheck the driveline angle after installation.
- Spline wear on the yoke
- Sealing surface condition
- Old nut and seal condition
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4797689 |
| UPC | 700006891991 |
| Component | Drive shaft pinion yoke |
Vehicle fitment
No vehicles, years or models are named. Direct fit alone does not confirm a vehicle, so compare the yoke with your existing part.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.









