Overview
The Crown Automotive Dana 44 JK Rubicon rear driver side axle shaft, part 68003557AA, is a 32 spline shaft for the rear left position. It comes with the retainer, bearing, seal and ring. It fits 2007–2018 Jeep Wrangler JK models across the covered trims.
The Rubicon name reflects the Dana 44 rear axle those trims came with from the factory. It is a direct fit that replaces the original driver side rear shaft.
Key features
- Rear driver side shaft
- 32 splines
- Includes retainer, bearing, seal and ring
- Direct fit replacement for the driver side rear shaft.
- Direct fit for 2007–2018 Jeep Wrangler JK models.
Driver side rear shaft install
The rear driver side shaft runs from the differential to the wheel on the left side of the vehicle. Because it carries drive torque, wear shows up as clunking when you shift between drive and reverse, or vibration under power. Look at the spline ends and the inner joint area when the shaft is out.
Because the retainer, bearing, seal and ring come with this shaft, use them as a complete set rather than reusing old pieces. Check the axle seal surface for grooves, and clean the bore before fitting the new shaft. Fill and check the axle fluid level once the job is finished.
- Compare the new retainer with the old one
- Inspect the seal bore for scoring
- Check fluid level after installation
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68003557AA |
| UPC | 848399047844 |
| Axle type | Dana 44 JK |
| Axle location | Rear |
| Side | Driver side |
| Position | Rear left |
| Spline count | 32 splines |
| Includes | Retainer, bearing, seal and ring |
| Fit | Direct fit |
Vehicle fitment
It fits 2007–2018 Jeep Wrangler (JK) models across the covered trims, including the Rubicon and Unlimited Rubicon.
Wrangler TJ, YJ and LJ models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the retainer, bearing, seal and ring come with the shaft, compare them with the parts you remove before you start the job.
What’s included
One driver side rear axle shaft with retainer, bearing, seal and ring.





