Overview
The TeraFlex 3043200 is a rear full float conversion kit for the Dana 44 Rubicon axle on the Jeep Wrangler JK. The kit covers 2007–2018 Wrangler JK models, including Rubicon, Sahara and Unlimited versions, so check the years against your vehicle.
The kit replaces the factory shaft-supported design with a two-bearing setup. The forged 4140 chromoly spindles carry the vehicle weight, so the 4340 chromoly axle shafts only transfer torque and are not loaded by weight or impact. The bearings are oil bathed and need no routine maintenance. The kit uses an 8-lug wheel pattern, and the stub axle is larger than stock. The OE park brakes are retained with the kit.
Key features
- Two-bearing full float design for the rear axle
- Forged 4140 chromoly spindles
- Case hardened 4340 chromoly axle shafts
- 13.5-inch slotted performance rotor and anchor bracket included
- Factory sensors maintained and protected
- Larger stub axle than stock, 8-lug pattern
Rear full float loads
In a full float rear axle, the wheel hub carries the vehicle weight and the axle shaft only transmits drive torque. That reduces stress on the shaft when the vehicle lands hard or a tire catches a rock, which is one reason drivers choose this design for heavy off-road use. It also means the hub and bearing condition matter more, since they hold the wheel in place.
Choosing a full float rear usually means planning the wheel and brake side together. The rotor and anchor bracket change how the brakes are mounted, so check pad wear and rotor condition after installation. Tire size and wheel offset affect how the bearings and bracket sit, so confirm clearance before buying. Keep an eye on the rear differential fluid and axle seals as part of routine service.
- Check rear brake pads and rotor after the first drive
- Inspect bearings and hub for play at each service
- Confirm wheel offset and tire clearance before ordering
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 3043200 |
| UPC | 843885035336 |
| Application | Rear Rubicon Dana 44 with 30 spline shafts |
| Bearing design | Two wheel bearings, full float |
| Spindle | Forged 4140 chromoly |
| Axle shaft | 4340 chromoly, case hardened |
| Rotor | 13.5 in performance slotted |
| Wheel pattern | 8 lug; does not retain factory bolt pattern |
| Stub axle | Larger than stock |
| Body style | 2 and 4-door models |
Vehicle fitment
The kit covers 2007–2018 Jeep Wrangler (JK) models, including Rubicon and Unlimited Rubicon. The Rubicon and Unlimited versions run 2007 to 2016, so match your year, model and trim to the fitment before ordering.
Wrangler TJ, LJ and JL models are not covered by this kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The OE park brakes, calipers and pads are retained, and all factory sensors are maintained and protected. The included 13.5-inch rotor and anchor bracket increase and balance braking.
What’s included
The full float conversion for the rear Rubicon Dana 44, with 30-spline shafts, forged spindles, a 13.5-inch slotted performance rotor and an anchor bracket.









